GE RM24926 - Manual (Page 10)

10
Code Search
If your device does not respond after you have tried
all the codes for your brand, or if your brand is not
listed, try searching for your code by following these
steps.
1. Manually turn on the device ( TV , VCR , etc.) to be
controlled.
2. Press and hold the CODE SEARCH button
until the red indicator stays on, then
release the
CODE SEARCH button.
3. Press and quickly release the desired
device button ( TV, VCR, etc.). The red
indicator blinks off once.
4. Press the ON•OFF button repeatedly
(up to 300 times) until the device
to be controlled turns off. The red
indicator blinks off with each button
press.
Most users will store VCR codes under the VCR button,
Cable codes under CABLE, etc. If (for example) you want to
store a VCR code under CABLE, first follow the procedure
for Direct Code Entry (previous page) and press CABLE in
step 2 of Direct Code Entry, then enter ANY VCR code in step
3 of Direct Code Entry. Then follow the steps above for Code
Search.
Note: Code Search starts from the currently stored four
digit number under that mode. Sometimes the first code
that “works” with your device may only allow limited
functionality (e.g. the MENU button might not work). There
may be a code that performs more functions. Continue the
code search process until the best code is found.
5. Press and release ENTER to install the
code.