JVC CA-UXE15 - Manual (Page 10)

7
To assemble and connect the AM loop
antenna
To assemble the AM loop antenna
To connect the AM loop antenna
Make sure to connect the wire correctly.
• If the AM loop antenna wire or speaker cords
are covered with vinyl, remove the vinyl to
expose the tip of the antenna by twisting the
vinyl.
• Make sure the antenna conductors do not
touch any other terminals, connecting cords
and power cord. Also, keep the antennas away
from metallic parts of the System, connecting
cords, and the AC power cord. This could
cause poor reception.
To connect the speaker cords
Make sure the both speakers are connected
correctly and fi rmly.
When connecting the speaker cords, match the
polarity of the speaker terminals.
Red (+) terminal : non-striped side of the
speaker cord
Black (–) terminal : striped side of the speaker
cord
• DO NOT connect more than one speaker
to each terminal.
• DO NOT allow the conductor of the
speaker cords to be in touch with the
metallic parts of the System.