JVC CA-UXH100 - Manual (Page 38)

7
English
To connect AM and FM antennas
1 Connect the supplied AM loop antenna to the
AM LOOP terminal.
Place the antenna away from the unit and adjust its
position for the best reception.
2 Adjust the position for the FM antenna for
the best reception.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals or connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Connecting Other Equipment
To connect audio equipment
You can connect audio equipment—used only as a playback
device.
• DO NOT connect any equipment while the
power is on.
• DO NOT plug in any equipment until all
connections are complete.
AM
LOOP
FM ANTENNA
ANTENNA
IMPORTANT:
Be sure to check that all connections have been made
before plugging in the power cord.
For playing other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX jacks by using audio cords with mini
plugs (not supplied).
When the audio equipment has pin jacks for audio output:
Be sure that the pin plugs of the audio cords are colored—
white plugs and jacks are for left audio signals, and red ones
for right audio signals.
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Use a screwdriver to move the voltage selector so the voltage
number is the same as the voltage where you are plugging in
the unit. (See the back cover page.)
DO NOT plug in before setting the voltage selector
on the bottom of the unit and all connection
procedures are complete.
NOW you are ready to plug in the unit.
• If the wall outlet does not match the AC plug, use the
supplied AC adaptor.
L
R
AUX
To
Audio equipment
To audio output
AM loop antenna
(supplied)
FM antenna
2
1
To audio output
Getting Started
(continued)
Do not connect the AC power cord until all other
connections have been made.
AC VOLTAGE
220V-240V
110V-127V
SET VOLTAGE
SELECTOR TO
PROPER VOLTAGE
BEFORE CONNECT-
ING UNIT TO AC
POWER SOURCE.
06-07_UX-H100[U].p65 04.3.24, 0:02 PM 7