JVC XV-M50BK - Manual (Page 18)

Getting started
16
Ge
ttin
g s
tarte
d
You can enhance the sound quality by connecting either of the unit's DIGITAL OUT jacks (OPTICAL or COAXIAL) to the
digital input of an amplifier, MD, etc. by using an optional digital cable. The digital audio signal from a disc is directly
transferred. If you connect the unit to a Dolby Digital or DTS decoder or an amplifier with a built-in decoder by using an
optional digital cable, you can enjoy high-quality surround sound.
When you make the digital connection, we recommend also to make the analog connection, because, depending on
discs, no signal may be output from the DIGITAL OUT.
When all the audio/video connections have been made, insert the smaller plug of the supplied AC power cord to the
unit’s AC IN connector, then insert the other end to the wall outlet. Make sure that plugs are inserted firmly. The
STANDBY indicator lights and setup is completed.
Warning
• Disconnect the power cord if you are not going to use the unit for a long time.
• Disconnect the power cord before cleaning the unit.
• Disconnect the power cord before moving the unit.
• Do not connect or disconnect the power cord with wet hands.
• Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or other
accidents.
Warning
• Do not damage, alter, twist, or pull the power cord, as this may cause fire, electric shock, or other accidents.
• To prevent any accidents or damages caused by an unsuitable AC power cord, only use the supplied power cord. If the
cord is damaged, contact a dealer and get the new power cord.
Do not put anything heavy, or the unit, on the power cord, as this may cause fire, electric shock, or other accidents.
To connect to audio equipment with a digital input
NOTES
• When you connect the unit's DIGITAL OUT to digital audio equipment, before using, make the “DIGITAL AUDIO OUTPUT”
setting in the “AUDIO” page of the preference display correctly according to the connected audio equipment. If the “DIGITAL
AUDIO OUTPUT” is not set correctly, loud noise may be generated from speakers, causing damage to your speakers. See
“DIGITAL AUDIO OUTPUT” on page 40.
• With the digital connection, the COMPRESSION setting in the AUDIO page of the preference display are invalid. Settings for
these items must be made from the decoder.
To connect the power cord
Digital equipment
Audio cable
(not supplied)
White
Red
The unit
White Red
Coaxial digital cable
(not supplied)
Optical digital cable
(not supplied)
PCM / STREAM
OPTICAL COAXIAL
Y P B P R
AV COMPU LINK
LEFT
RIGHT
AUDIO OUT DIGITAL OUT
VIDEO S-VIDEO
VIDEO OUT
COMPONENT
AUDIO
RIGHT
LEFT
IN
OPTICAL
COAXIAL
DIGITAL
IN
When using the DIGITAL OUT (OPTICAL)
jack, remove the protection cap. Do not
lose the removed cap. When the DIGITAL
OUT (OPTICAL) jack is not used, fix the
protection cap into the jack.
M50-ENG.book Page 16 Friday, March 9, 2001 12:00 PM