Jensen VM9114 - Manual (Page 40)

36
VM9114
Error Messages
Care and Maintenance
1. Use only a clean silicone cloth and neutral detergent to clean the front
panel or monitor. A rough cloth and non-neutral detergent (such as alco-
hol) may result in scratching or discoloration.
2. Do not get water or cleaning fluids on the unit.
3. If the temperature inside the player gets too hot, a protective circuit
automatically stops play of the disc. If this occurs, allow the unit to cool
before operating the player again.
4. Never insert anything other than a 5” (12 cm) compact disc into the player
as the mechanism can be damaged by foreign objects.
5. Do not attempt to use a 3” (8 cm) CD-Single disc in this unit, either with or
without an adaptor, as damage to the player and/or disc may occur. Such
damage is not covered by the Warranty on this product.
Interruption
occurred dur-
ing playback Disc is dirty or scratched Clean disc or replace
File is damaged/bad
recording Recreate disc with good files
Table 7: Error Messages
Message
Displayed
Cause Corrective Action
Loading Disc is being read
No Disc Disc is dirty Clean disc with soft cloth
Disc is upside down Insert disc with label side up
Disc not present in loading
compartment Insert disc
Bad Disc Disc is dirty Clean disc with soft cloth
Disc is upside down Insert disc with label side up
Unknown
disc Disc format is not compatible
with this unit
Region Error DVD is not compatible with
region code of unit
Error Illegal mechanism operation Press EJECT key for 5 seconds to
reset loading mechanism
Table 6: Troubleshooting
Problem Cause Corrective Action