JVC FS-A52 - Manual (Page 11)

– 8 –
Continued
Connecting Speakers
R L
– –
+ +
R L
SPEAKER IMPEDANCE
MIN 4 Ω
To connect speakers
You can connect the speakers by following the procedure
below:
1
If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2
Open the speaker terminal.
3
Insert the end of the speaker cord to the terminal.
Match the polarity: White cord to (+) terminal and
black cord to (–) terminal.
4
Close the speaker terminal on the rear of the unit.
Use only speakers with the speaker impedance—4 Ω to16 Ω.
Speaker cord Speaker cord
Rear of the right
speaker Rear of the left
speaker
1
Speaker terminals 3,4 2
To remove the speaker grilles
The speaker grilles are removable.
To remove the speaker grille, insert your fingers at the top
of the speaker grille, then pull towards you. Do the same at
the bottom.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
Projections
Holes
Speaker grille
EN01-09FS-A52[J]f.pm6 02.1.22, 14:17 8