JVC CA-MXGT700 - Manual (Page 11)

– 8 –
Connecting Other Equipment
You can connect both analog and digital equipment.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are color coded:
White plugs and jacks are for left audio signals, and red ones
for right audio signals.
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX IN jacks by using audio cords (not
supplied).
To connect audio equipment with an optical digital
input terminal
You can record CD sound onto the connected digital
equipment.
Connect an optical digital cord (not supplied) between the
optical digital input terminal on the other equipment and the
DIGITAL OUT [OPTICAL] terminal.
For CA-MXGT700:
To remove the speaker grilles
The speaker grilles are removable as the illustration below.
To remove the speaker grille, insert your fingers around the
projection at the top of the speaker grille, then pull gently
towards you by holding the side. Do the same for the rest of
projections each at a time.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
DIGITAL OUT
(OPTICAL)
To audio output
AUX IN
Audio/video
equipment
To optical
digital input
Before connecting the other equipment,
remove the protective plug from the
terminal.
Audio equipment
with an optical digital
input
Protective
plug
Projections
Speaker grille
SP-MXGT700
Holes
Continued
01-13.MXGT700[UJ]2.pm6 02.5.27, 2:30 PM 8