JVC DR-M70SEK - Manual (Page 9)

9
Bef
o
re yo
u st
art
EN
Rear panel
1 ANTENNA IN
• Connect to an antenna or a cable.
2 ANTENNA OUT
• Connect to the Aerial jack on your TV, cable box
or direct broadcast system. Use the supplied RF
cable.
3 AV2 (DECODER)
• Connect to VCR, camcorder, or other
Audio-Video equipment. Use a commercially
available Scart cable.
4 AV1 (TV)
• Connect to the Scart jack on your TV. Use a
commercially available Scart cable.
5 S-VIDEO OUT jack
• Connect to the S-Video input jack on your TV.
Use a commercially available S-Video cable.
6 S-VIDEO IN (AV3) jack
• Connect to the S-Video output jack on your
VCR, camcorder or other equipment. Use a
commercially available S-Video cable.
7 AUDIO IN (AV3) jacks
• Connect to the audio output jacks on your VCR,
camcorder or other Audio-Video equipment.
Use commercially available Audio cables.
8 ANALOG AUDIO OUT jacks
• Connect to the audio input jacks on your TV.
Use commercially available Audio cables.
9 DIGITAL AUDIO OUTPUT
PCM/BITSTREAM (COAXIAL) jack
• Connect to an amplifier with digital input jacks
such as a Dolby Digital decoder or DTS
decoder. Use a commercially available Coaxial
cable.
10 Mains cable
• Connect to a standard AC outlet.
Note
• Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage
to the unit.
• This unit does not have an RF modulator.
IN
OUT
AV2 (DECODER)
AV1 (TV) ANTENNA
S-VIDEO
OUT IN (AV3)
AUDIO IN
(AV3)
ANALOG
AUDIO OUT
DIGITAL AUDIO OUTPUT
PCM/BITSTREAM
L L
R R COAXIAL
1 2 3 4 5 6 7 8 9 10
E6851BD_EN.book Page 9 Tuesday, August 2, 2005 5:57 PM