JVC XV-522SL - Manual (Page 19)

Getting started
16
Getting star
ted
XV-521BK/XV-523GD [B] EN
LVT0435-002A
English
Français
To use the remote control unit for TV operation
You can operate your TV from the remote control unit.
Setting the remote control signal for operating your TV.
1 Holding down TV/VIDEO, enter the manufacturer code of your TV listed below by using the numeric buttons (0 - 9).
Do not release TV/VIDEO. Keep holding it until the next step is completed.
2 Press 7 (STOP) while holding down TV/VIDEO.
The following buttons can be used for operating the TV:
3 Try to operate your TV by pressing DVD - TV while holding SHIFT.
If your TV turns on or off, you have successfully set the control signal.
• The remote control unit is initially set for operating a JVC TV.
• If there is more than one code listed for the manufacturer of your TV, try them one by one until you succeed.
NOTES
To control the volume of a JVC’s amplifier or receiver
You can control the volume of a JVC’s amplifier or receiver by using the AMP VOL button on the remote control unit.
AMP
VOL
Manufacturer code list
Example:
To enter the manufacturer code “01”:
Press “0” then “1.”
No. Manufacturer
10 PANASONIC
11 ITT
12 MIVER
13 HITACHI
14 TOSHIBA
15 MITSUBISHI
16 FINLUX
17 NOKIA
18 SHARP
No. Manufacturer
01 JVC
02 JVC
03 JVC
04 JVC
05 THOMSON
06 FERGUSON
07 PHILIPS
08 GRUNDIG
09 SONY
No. Manufacturer
19 SAMSUNG
20 FUNAI
21 GOLDSTAR
22 NEC
to
SHIFT
10 1
TV 1
TV 0 TV -/--
+10 0
TV/VIDEO
TV
VOL
TV
ch
Turns the TV on or off.
Changes the TV channels.
Adjusts the TV volume.
Selects the TV channels.
*For some TVs, pressing “+10” while holding down SHIFT
functions as the “-/--.” “10” functions as the ENTER button
if your TV requires pressing the ENTER button after selecting a
channel number.
Switches input mode (either TV or VIDEO).
SHIFT
DVD
TV