JVC LD-HD2KE - Manual (Page 5)

5
QUICK START
Connection with Other Devices
Before connecting to other devices, ensure to turn off the power supply of the device to be connected with the digital video
processor.
Ⅵ Connecting to a Projector
● Read through the projector’s instruction manual thoroughly.
● Depending on the DVI cable used, signals may be attenuated and images may become unstable. Use high-quality DVI
cables that are 5 m or shorter. When a DVI cable longer than 5 m is used, make use of a distribution system or an optical
fiber cable.
Caution on Devices to be Connected
Please refer to the list of ‘Devices Compatible with this Product’ on the front page for devices that can be
connected with this unit. Performance of this unit will not be guaranteed if it is connected with a device not
specified in the list.
DVI
VIDEO IN
H/C SYNC V SYNC RS-232
DVI INPUT
I/R REMOTE
UTPUT DVI OUTPUT 100-240 VAC 50-60Hz 35 WATTS
SCREEN
DVI Connection Cable (sold separately)
Right End of this Unit
Setup of this Unit
1. Connect the supplied power cord to the power supply in-
put terminal on this unit. Connect the earth wire to the
equipped earth terminal in the building, followed by in-
serting the plug of the supplied power cord into the wall
outlet.
2. This unit will be initialized once the plug of the power cord
is inserted into the power outlet. Upon completion of ini-
tialization, this unit switches to the Standby mode (LED
turns red).
3. Press the Power/Standby button on this unit (or Power
button on the remote). Once the unit is turned on, the
LED turns green.
4. Press the Menu button on the remote for 5 seconds or
more to display the Setup Menu on this unit’s display
panel. After the Setup Menu is displayed, use the Func-
tion Up/Down keys on the remote to select an adjustment.
Select the set values accordingly using the Value Left/
Right keys on the remote.
5. Select Set: SCANRATE and set the value to 1920 x 1080.
Press the STORE key on the remote. The message “Are
You Sure” is displayed on the display panel of this unit.
Press the STORE key on the remote again to set the scan
rate.
6. Select Set: Active Output and set the value to Digital.
7. Select Set: Screen Shape and set the value to Wide Screen.
8. Press the Menu button on the remote to exit the Setup
Menu.
Profile Setting
This unit can store up to 8 profiles. Each profile stores values
that have been set for this unit during each adjustment. Select
the profile number (1 - 8) at the OSD and press the STORE
key on the remote to save the current settings. For further
details, please refer to ‘OSD’. (
☞ Page 10)
Video Image Adjustment
The following item can be adjusted according to the input
signals. Adjusted values can also be stored in the profile.
● BRIGHTNESS (☞ Page 11)
● CONTRAST (☞ Page 11)
● COLOR (☞ Page 12)
● TINT (☞ Page 12)
● DETAIL (☞ Page 12)
● ADVANCED COLOR SYSTEM (☞ Page 12)