Installation – JVC LD-HD2KE User Manual
Page 6
6
INSTALLATION
INSTALLATION
Accessories
The following accessories are packed together with this unit.
Please confirm all items. If any item is missing, please contact
your dealer.
Placement
The processor can be either placed on a table or rack
mounted. A rack mounting installation kit is available. Securely
mount the side rack brackets with the screws that are provided
with the kit.
Ventilation
The unit uses convection to cool. A fan is not needed. As hot
air raises out of the top vent, cool air is drawn in from the
bottom and side. These vents must not be blocked. When
rack mounted, a minimum of 1.75” (1 rack unit height) of free
space is required above and below the unit to allow for proper
cooling. A forced air fan should be added to the rack
installation if power amps are located in the same air space.
Do not install unit above power amps.
Connections
Because of the high performance of this unit it is very important
to use the highest quality cables possible, for both input and
output signals.
To avoid AC ground loop problems, the source equipment,
this unit and projector should all be running on the same
grounded AC power line (one rated for the power
requirements).
1
S-Video input (4-pin DIN) for sources such as DVDs,
Satellite systems, S-VHS tape decks (when using S-VHS
tapes only), Hi-8 tape decks.
2
Composite video input (BNC) for sources such as
Laserdisc players, cable TV, VHS tape decks, 8mm tape
decks.
3
YPrPb/RGBs Input (BNC): 480i and HDTV scan rates are
sent to the internal processor and then output at the se-
lected scan rate. If the output is set to analog RGBHV or
digital DVI, the unit will automatically transcode the YPrPb
HDTV to RGBHV.
Note on DVDs:
For proper aspect ratio and to insure the highest quality
image from the DVD player, be sure to set the DVD screen
shape to 16:9 in the DVD player’s Setup menu. See the
DVD player’s owner’s manual for details.
4
High scan rate input (D-sub15 pin) for sources such as
HDTV signals or computers are passed through to the
projector. The signal is sent to the outputs in the same
format as the input unless Transcoding is selected. YPrPb
from HDTV sources can be transcoded to RGBHV, as
well. Use a BNC to D15 breakout cable if necessary. The
Green, Red, Blue BNCs are used for YPrPb.
5
D-sub15 pin connector output for use with computer moni-
tors or to a second display device. Use only short cable
runs. This output can be used at the same time as the
BNC outputs.
6
DVI Input. The DVI Input will automatically process 480p,
720p and 1080p signals. Computer rates are not sup-
ported for processing but may be passed through to the
DVI output if any of the pass-through inputs are selected.
This unit will not convert a computer DVI output to the
analog output.
For incompatible input signals, a “Not Supported”
message will be displayed on the LCD display
and the image will be muted (black screen).
Y/C
VIDEO
RED/Pr
INPUT
GREEN/Y
BLUE/Pb
C-SYNC
HDTV INPUT
RED/Pr
GREEN/Y
OUTPUT
BLUE/Pb
H/C SYNC
V SYNC
RS-232
DVI INPUT
I/R REMOTE
MONITOR OUTPUT
DVI OUTPUT
100-240 VAC 50-60Hz 35 WATTS
SCREEN
2
1
3
8
9 p
q
4
5
6
7
w
• Instructions
• Remote Control
• Power Cord
• AA/R6 size Battery
(for operation confirmation)
• Guarantee
Note