JAI VIS-CAM System TS-1327EN - Manual (Page 79)

Appendix B: J-Panel Functional & Connector Description 67
VIS-CAM System
6.2.3 (c) Ethernet Interface
100 Mb Ethernet interface. The signals are routed directly to RJ45 connector X11. The cable to the
camera must be a Cat 5e or preferably a Cat 6 cable. The wire color marking on the PCB uses
standard Ethernet wire colors.
6.2.3 (d) Power output
Voltage 24VDC from power supply connected to X6 or X7
Current 2A fused
6.2.4 Connector physical Interface
Table 18 Physical interface table
Pin Signal Description
Connection to
I/O Board X4
Remarks
1 Ethernet A+ Ethernet signal to gigabit switch pin 1 Cat5e/6 cable white/orange
2 Ethernet A- Ethernet signal to gigabit switch Pin 2 Cat5e/6 cable orange
3 Ethernet B+ Ethernet signal to gigabit switch Pin 3 Cat5e/6 cable white/green
4 Ethernet B- Ethernet signal to gigabit switch Pin 4 Cat5e/6 cable green
5 Ethernet C+ Ethernet signal to gigabit switch Pin 5 Cat5e/6 cable white/blue
6 Ethernet C- Ethernet signal to gigabit switch Pin 6 Cat5e/6 cable blue
7 Ethernet D+ Ethernet signal to gigabit switch Pin 7 Cat5e/6 cable white/brown
8 Ethernet D- Ethernet signal to gigabit switch Pin 8 Cat5e/6 cable brown
9 Gnd Power ground Pin 9 Black wire in Red/Black pair
10 +24V dc Supply voltage Pin 10 Red wire in Red/Black pair
11 Vinit + Balanced trigger pulse positive Pin 11 White wire in Brown/White pair
12 Vinit - Balance tripper pulse negative Pin 12 Brown wire in Brown/White pair
13 RS485D+ RS485 Data+ for Lane Controller Pin 13 White wire in Red/White pair
14 RS485D- RS485 Data- for Lane Controller Pin 14 Red wire in Red/White pair
15 RS485D= RS485 Data+ for Lane Controller Pin 15 White wire in Orange/White pair
16 RS485D- RS485 Data- for Lane Controller Pin 16 Orange wire in Orange/White pair