JAI VIS-CAM System TS-1327EN - Manual (Page 89)

Appendix B: J-Panel Functional & Connector Description 77
VIS-CAM System
6.8.2 Connector specification
Connector type: 8 pole WAGO pluggable terminal block
Connector on board: WAGO 734-238
Cable part: WAGO 734-208
6.8.3 Connector signal specifications
6.8.3 (a) Power output
Voltage: 24 V DC from power supply connected to X6 or X7
12 V DC from regulator on board
Current: 0.3A fused
6.8.3 (b) Databus D0 and D1
D0 and D1 are RS485 databus signals from the light sensor.
6.8.4 Connector physical Interface
Table 30 RS485 physical connections
Pin Signal Description Connection to
1 24V dc 24v Power output
2 Gnd Power return
3 +12V dc 12V power output
4 Gnd Power return
5 D0+ RS485 databus D0+
6 D0- RS485 databus D0-
7 D1+ RS485 databus D1+
8 D1- RS485 databus D1+
6.9 X11: Ethernet Interface from Camera 0
Figure 77. Interface from Camera 0
6.9.1 Functionality
Ethernet interface from Camera 0 to Ethernet switch.