JVC KD-LX10R - Manual (Page 33)

33
ENGLISH
To turn on/off the key-touch tone
You can deactivate the key-touch tone if you do not want it to beep each time you press a
button. When shipped from the factory, the key-touch tone is activated.
• BEEP ON:
Activates the key-touch tone.
• BEEP OFF: Deactivates the key-touch tone.
To select the scroll mode
You can select the scroll mode for the disc information if it consists of more than 10 characters.
When shipped from the factory, Auto Scroll mode is set to “ONCE.”
• ONCE: Scrolls only once.
• AUTO: Repeats the scroll (in 5-second intervals).
• OFF:
Cancels Auto Scroll.
Note:
Even if the scroll mode is set to “OFF,” you can scroll the display by pressing DISP for more than 1
second.
To select the external component to use
You can connect the external component to the CD changer jack on the rear using the Line
Input Adaptor KS-U57 (not supplied).
To use the external component as the playback source through this unit, you need to select
which component — CD changer or external component — to use. When shipped from the
factory, CD changer is selected as the external component.
• LINE INPUT: To use the external component other than the CD changer
• CHANGER: To use the CD changer
To make the front panel look flat (hiding the control panel)
When operating the receiver using the remote control, you can hide the control panel to make
the front panel look flat. When shipped from the factory, “FLAT OFF” is selected.
• FLAT ON:
The control panel will not come out when you turn on the unit.
To use the control panel, press
4 so that the control panel comes out. If
no operation is done for about 10 seconds, it automatically goes back into the
receiver.
• FLAT OFF: You can use the control panel normally.
Note:
When “FLAT ON” is selected, you can eject a CD by holding
4
.
To change the FM tuner selectivity
In some areas, adjacent stations may interfere with each other. If this interference occurs,
noise may be heard. This unit has been set to automatically reduce this interference noise
(“AUTO”) when shipped from the factory.
• AUTO:
When this type of interference occurs, this unit automatically increases the
tuner selectivity so that interference noise will be reduced. (But the stereo effect
will be also lost).
• WIDE: Subject to the interference from adjacent stations, but sound quality will not be
degraded and the stereo effect will not be lost.
EN29-38.LX10R[E]/F 00.1.12, 6:37 PM 33