Setting the ta volume level, Automatic clock adjustment – JVC KD-LX50R User Manual

Page 19

Advertising
background image

19

ENGLISH

Changing the display mode while listening to an FM

station

You can change the initial indication on the display to either station name (PS NAME) or to
station frequency (FREQUENCY), while listening to an FM RDS station.
• See also “Changing the general settings (PSM)” on page 51.

1. Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears

on the display.

2. Press

¢

or

4

to select “TUNER DISP (display).”

3. Press + or – to set to the desired indication (“PS NAME” or “FREQUENCY”).

Note:

By pressing DISP, you can also change the display while listening to an FM RDS station.
Each time you press the button, the following information appears on the upper part of the display:

* Then, the display goes back to the original indication in several seconds.

Setting the TA volume level

You can preset the volume level for TA Standby Reception. When a traffic programme is
received, the volume level automatically changes to the preset level.
• See also “Changing the general settings (PSM)” on page 51.

1. Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears

on the display.

2. Press

¢

or

4

to select “TA VOLUME.”

3. Press + or – to set to the desired volume.

Automatic clock adjustment

When shipped from the factory, the clock built in this unit is set to be readjusted automatically
using the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock adjustment, follow the procedure below.
• See also “Changing the general settings (PSM)” on page 51.

1. Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears

on the display.

2. Press

¢

or

4

to select “AUTO ADJUST.”

3. Press – to select “ADJUST OFF.”

Now automatic clock adjustment is canceled.

To reactivate clock adjustment, repeat the same procedure and select “ADJUST ON” in
step 3 by pressing +.

Note:

It takes about 2 minutes to adjust the time using the CT data. So, you must tune to the station for more

than 2 minutes continuously; otherwise, the clock time will not be adjusted.

Station Frequency

PS (Station name)

PTY (Programme type)

EN12-19.KD-LX50R[E]/f

00.3.22, 10:34 AM

19

Advertising