Operating the receiver using the voice commands – JVC KD-LX50R User Manual
Page 42
42
ENGLISH
STOP
PLAY
1
Turn on the power.
The display illuminates and the control panel comes out.
2
Activate the Voice Recognition System.
“SPEAK” starts flashing on the display after the voice navigation “Please
speak now” (or a beep).
3
Speak one of the voice commands to the microphone while
“SPEAK” is flashing on the display.
The receiver performs what you command it to do. (Ex. when
you speak “Jazz 89.”)
If your voice cannot be recognized
The unit will ask you to speak again (and more) until “V.COMMAND” disappears from the
display.
If your voice command cannot be carried out and “V.COMMAND” disappears, repeat from
step 2.
1,2
4
ATT/STR*
Voice remote
* ATT stands for “attenuator,”
and STR stands for “store.”
Basic Procedure
Operating the receiver using the voice commands
EN30-47.KD-LX50R[E]/f
00.3.22, 10:36 AM
42