John Lewis JLBIOS608 - Manual (Page 47)

47
Putting the door glass panels back.
1. From above insert the door glass panels at
an angle into the door profile at the bottom
edge of the door one after the other and
lower them.
3
Insert the smaller panel first, then the
larger panel.
2. Take hold of the door trim (B) at each side,
position it on the inside edge of the door
and plug the door trim (B) into the upper
edge of the door
3
On the open side of the door trim (B)
there is a guide bar (C). This must be
pushed between the outer door panel
and the guide corner (D).
The clip seal (E) must be snapped in.
3. Open the oven door as far as it will go.