Johnson Controls TopClean AS - Manual (Page 5)

3 IM-AS/02.00 GB (0412)
TopClean
Item
No. r.p.m.
kW Volt Hz
Nastagatan 19, Örebro, Sweden · Tel +46 (0)19 21 83 00
Pump type
Serial No.
Name plate
Warning: Pay great attention to the text parts indicated by this symbol.
Danger: The non-observance of instructions can cause serious damage
to persons and/or objects.
Danger: Only skilled personnel is allowed to carry out operations
concerning the electric parts.
1.0 Introduction
• Read the instructions carefully and keep them for future consultation.
• Johnson Pump reserves the right to make any changes to the documentation it
deems necessary without being obliged to update publications that have already
been issued.
• When requesting information, spare parts or assistance, always specify the pump
type and serial number in order to ensure fast and efficient service: the complete
code is given on the plate and in the purchase documents.
2.0 Symbols
3.0 Safety warnings
When the pump is working the following occurs:
• Electric parts are in tension.
• Mechanical parts are moving.
• Pump body, pipelines and articulations are under internal pressure. Therefore do not
remove any protection or locking, do not loosen screws or clampings, as this can
cause serious damages to persons or objects. The clamp joining the pump casing and
the cover must be well tightened and it should not be easily unscrewed by hand. The
tightening of the clamp must be carried out by means of a key and not by hand.
• Non-observance of inspection and maintenance can cause damages to persons and
objects, especially when dangerous or toxic liquids are pumped.
• When pumping liquids at a temperature over 60°C, adequate protection and
warning signals are required.
• When you buy a pump with bare shaft, motor coupling operations have to be
carried out according to technical directions and law, providing adequate
rotections for joints, gear belts, etc.
• Operations on the electric parts have to be carried out by skilled personnel,
according to technical directions and law, on authorisation of the responsible
installer.
• Installation must ensure adequate ventilation, in order to cool the engine, as well as
enough space for maintenance operations.