JVC GR-D347U - Manual (Page 17)

MasterPage: Video_Heading0_Right
EN
17
VIDEO RECORDING & PLA
YBACK
VIDEO RECORDING
NOTE:
Before continuing, perform the procedures listed
below:
● Power (੬ pg. 11)
● Loading A Cassette (੬ pg. 16)
1
Remove the lens cap. ( ੬ pg. 11)
2
Open the LCD monitor fully.
3
Set the Power Switch to “REC” while pressing
down the Lock Button located on the switch.
● The POWER/CHARGE lamp lights and the
camcorder enters the Record-Standby mode.
“ PAUSE ” is displayed.
● To record in LP (Long Play) mode, ੬ pg. 23.
4
To start recording, press the Recording Start/
Stop Button. “ REC” appears on the display
while recording is in progress.
5
To stop recording, press the Recording Start/
Stop Button again. The camcorder re-enters the
Record-Standby mode.
Approximate recording time
NOTES:
● If the Record-Standby mode continues for
5 minutes and no operation is performed
(
“ PAUSE ” indicator may not appear), the
camcorder’s power shuts off automatically. To turn
the camcorder on again, push back and pull out
the viewfinder again or close and re-open the LCD
monitor.
● When a blank portion is left between recorded
scenes on the tape, the time code is interrupted
and errors may occur when editing the tape. To
avoid this, refer to “Recording From The Middle Of
A Tape” (
੬ pg. 19).
● To turn the melody sounds off, ੬ pg. 22, 24.
Tape Remaining Time
Approximate tape remaining
time appears on the display.
“---min” means the
camcorder is calculating the
remaining time. When the
remaining time reaches 2 minutes, the indication
starts blinking.
● The time required to calculate and display the
remaining tape length, and the accuracy of the
calculation, may vary according to the type of tape
used.
Basic Recording
Tape
Recording mode
SP LP
30 min. 30 min. 45 min.
60 min. 60 min. 90 min.
80 min. 80 min. 120 min.
Recording Start/Stop Button
Lock Button
Zoom Lever
POWER/CHARGE Lamp
VIDEO RECORDING & PLAYBACK
GR-D347US_EN.book Page 17 Wednesday, July 12, 2006 3:51 PM