Jwin JX-CD477 - Manual (Page 2)

E.1
LOCATION OF CONTROLS
CONTROL OPERATION AND FUNCTION
POWER SUPPLY
Your CD player requires 2 size “AA” alkaline batteries
(not included), or use the AC adaptor 4.5V 600mA
(not included)
AC ADAPTOR OPERATION
Plug one end of the AC adaptor into the DC 4.5V jack,
then plug the other end into AC wall outlet. (not included)
PRECAUTIONS ON USING THE AC ADAPTOR
Put in AC adaptor spec. Please make sure you purchase the correct AC adaptor.
Use of an incorrect AC adaptor will damage the unit.Don’t touch the AC adaptor with
wet hands. Doing so is dangerous, as this could result in an electric shock.
If the adaptor plug is insert into the DC Jack of the Player, the power supply automatically
switch to the AC/DC power and the batteries supply will be disconnected.
DC OPERATION
ALKALINE BATTERY INSTALLATION (NOT SUPPLIED)
Insert two AA batteries (not supplied) into the battery compartment on the bottom
of the unit. Be sure to observe the proper polarity.
CHARGING AND USE OF RECHARGEABLE BATTERIES
This unit can fully recharge the specified rechargeable batteries, in approximately
15 hours. The rechargeable batteries (NOT supplied) should be recharged before
they are used for the first time or they have not been used for a long period of time
(over 60 days).
1. Open the battery compartment cover and insert two of the recommended
rechargeable batteries, matching polarity. (1.2V 650mA).
ALL BATTERIES MUST BE OF RECHARGEABLE NICKEL-CADMIUM TYPE, OTHERWISE
THE BATTERIES MAY EXPLODE OR LEAK.
2. Plug in the AC adaptor. (not included)
(NOT INCLUDED)
OPEN
CD SKIP
CD MODE
PROGRAM
LCD DISPLAY
STOP BUTTON
(power off)
DOOR OPEN
BATTERY DOOR
PLAY/PAUSE
(power on)
RECHARGE HOLD
BASS BOOST
VOLUME CONTROL
PHONES JACK
LINE OUT JACK
DC IN 4.5V
ADAPTOR JACK
ANTI-SKIP
RECHARGE
INDICATOR