JVC CA-MXDK1 - Manual (Page 8)

5
@
Subwoofers (for CA-MXDK5 and MX-DK3)
• MX-DK3 has only one subwoofer.
• When connecting the speaker cords, match the polarity of
the speaker terminals: (+) to (+) and (–) to (–).
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
¤
Surround speakers (for CA-MXDK5 and
MX-DK3)
• The surround speakers connected can reproduce the bass
sounds recorded in front left and right channels, but cannot
reproduce the surround signals recorded in DVD multi-
channel discs.
#
Main speakers
• When connecting the speaker cords, match the polarity of
the speaker terminals: (+) to (+) and (–) to (–).
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• The speakers are magnetically shielded to avoid color
distortions on TVs. However, if not installed properly, it
may cause color distortions. So, pay attention to the
following when installing the speakers.
– When placing the speakers near a TV set, turn off the TV’s
main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV’s
main power switch again.
Some TVs may still be affected even though you have
followed the above. If this happens, move the speakers away
from the TV.
For the Australian model
Stereo mini plug
(not supplied)
From left
subwoofer From right
subwoofer
MX-DK3
CA-MXDK5
From the subwoofer
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
From right surround
speaker (not supplied)
From left surround
speaker (not supplied)
From right
main speaker
From left
main speaker
MX_DK5_3_1.book Page 5 Tuesday, February 7, 2006 11:49 AM