Jonsered CS 2240 - Manual (Page 28)

English – 29
Repair instructions
7.8 Ignition module and flywheel
– refitting
1
Fit the flywheel on the crankshaft journal. Turn the
flywheel so that the key lines up with the keyway in
the shaft.
Fit the nut on the shaft and tighten to a torque of
25-30 Nm (see figure 11).
2
To refit the ignition module proceed as follows:
Turn the flywheel so that the magnets are in line with
the ignition module. Fit the ignition module with the
plastic feeler gauge (502 51 34- 02) held in position
at the same time, without tightening the bolts. Fit the
earth cable (black) (A). Set a distance of 0.3 +/- 0.1
mm, between the ignition module and magnet. The
measurement applies to the two lowest lugs on
the ignition module. Tighten the screws, tightening
torque 4.5–6 Nm. Fit the blue cable on the ignition
module (see figure 12).
3
Then refit:
• cable guide and press the leads into position
• HT lead
• starter assembly, tighten to a torque of 2.5–3.5
Nm
• cylinder cover
When replacing the cables, they are fitted on the
stop switch as shown in middle figure on the pre-
vious page.
Fig 11
Fig 12