JDS Uniphase Portable Optical Network Tester MTS-8000 - Manual (Page 3)

MTS-8000 Tester
3
Transport Confi guration
Primary Port Bank
• 2.5 Gb/s, 622 Mb/s, and 155 Mb/s SDH/SONET
Tx/RX (1310 nm, 1550 nm)
• 10/100/1000 Mb/s Ethernet
• 1 GigE Tx/Rx (850 nm, 1310 nm, 1550 nm)
Secondary Port Bank
• 10/100/1000 Mb/s Ethernet
• 1 GigE Tx/Rx (850 nm, 1310 nm, 1550 nm)
10 Gb/s Port Bank
• 10 Gb/s SDH/SONET (1310 nm, 1550 nm)
• 10 GigE LAN & WAN (850 nm, 1310 nm, 1550 nm)
Optical Connection Check Interfaces
• High accuracy power meter
• Continuous wave power source
• Visual fault locator Port Bank #4
• T1 and E1 balanced and
unbalanced Tx/Rx
Port Bank #5
• E3, DS3, STS-1, E4 Tx/Rx
• STM-1 (e) Tx/Rx
Transport Module
• Contained in one 5 cm module
– PDH / T-carrier interfaces include
DS1, E1, E3, DS3, E4, STS-1 and STM-1e
– SDH/SONET interfaces (1310 nm, 1550 nm) include
155 Mb/s, 622 Mb/s, 2.5 Gb/s, 10 Gb/s
– Ethernet interfaces (850 nm, 1310 nm and 1550 nm)
include
10/100/1000 Mb/s electrical and 1 GigE Optical
– 10 GigE LAN + WAN
• Only 2.5 kg fully populated, total weight < 7 kg
• Fully scalable to meet your current and future needs
• Optical and electrical signal level measurements
• Up to 2.5 hours at 10 Gb/s rates with one battery
(2 batteries possible)
• Field exchangeable connectors for all standard connector
types
• SDH/SONET testing
– Mixed payload generation and analysis
– Concatenated signals
– Automatic Protection Switching (APS)
– Overhead byte manipulation and analysis
– Round Trip Delay (RTD)
• Ethernet testing
– Single and dual port Ethernet confi guration
– Testing on Layer 1, 2 and 3 (IP)
– VLAN support
– Constant, burst and ramp traffi c generation
– Traffi c fi lter capabilities
– Automated RFC2544 testing
– Loop-up /loop-down of far end device