Jensen JiMS-60 - Manual (Page 9)

8
iPod OPERATION
1.) Use the iPod adapter included with your iPod and insert it into the
docking area. Your iPod can now be docked by placing the connector
on the bottom of the iPod onto the connector in the docking bay.
Note: Please be careful when docking the iPod onto the 30-pin connector
in the docking bay. Improper installation or excessive force could
damage the 30-pin connector on the iPod or in the docking system.
2.) Press the ON/STANDBY button to turn on the unit.
3.) Slide the FUNCTION button to select iPod mode. The iPod will start
playing automatically and start charging immediately. You can also
play the iPod by pressing the iPod PLAY/PAUSE button when the unit
is in a different function mode.
4.) Press the iPod PLAY/PAUSE button to pause or resume iPod
playback.
5.) Adjust the sound level by rotating the VOLUME control knob.
Note: The volume level cannot be adjusted using the volume control on
your iPod after it is docked.
6.) The iPod charges at all modes and during playback except when in
AM radio mode.
iPod playback control:
Press the iPod PLAY/PAUSE
button to pause or resume the iPod
playback;
Press the SKIP
or button to skip to the next or previous song;
Press and hold the SKIP
or button for fast-forwarding or fast-
rewinding during playback.
ALARM OPERATIONS
SETTING THE WAKE UP TIME
1. Press and hold the ALARM SET button and repeatedly press the HOUR
button to set the correct wake up Hour.
2. Press and hold the ALARM SET button and repeatedly press the MINUTE
button to set the correct wake up Minute.
NOTE
There is a PM indicator located in the top left-hand corner of the clock display.
Be sure to observe the PM indicator when setting the alarm to make sure the
alarm time is set correctly for AM or PM. If the PM indicator is 'On', the alarm
time will be "PM". If PM indicator is 'Off, then the alarm time will be "AM ".