Names and functions of various parts, Front panel, Operate] operate button/led – JVC BR-DV600AE User Manual

Page 10: Cassette slot, A. dub] audio dubbing button/led, Input sel.] input video signal se- lection switch

Advertising
background image

E-10

Mini

PROFESSIONAL

SET

MENIU

EJECT

REC

PLAY

PAUSE

REW

STOP

FF

DVCAM NTSC

PAL REC INH.

CH-1/3

CH-2/4

BR-DV3000

A.DUB

OPERATE

INPUT SEL.

REMOTE SEL.

MIC

SERIAL

WIRELESS

9PIN

LINE

DV

Y/C

2

4 3

1

1

[OPERATE] Operate button/LED

● Press this button to turn on the power and op-

erate the unit. (Operate ON)
Press this button again to turn off the power.
(Operate OFF)

● The OPERATE LED lights up as follows.

Operate ON

: the LED lights up green

Operate OFF : the LED lights up red
VTR error

: the LED blinks in red

Memo

● When the DC IN MODE item of the SYS-

TEM menu is set to “OPE ON” and power is
supplied to the

1

DC IN terminal located at

the rear panel, the unit goes into the OPER-
ATE ON state even if this button is not
pressed.

● Even when the power has been turned off

with this button, a small amount of electric-
ity will still be channeled into the unit.
Therefore, if the unit is not going to be used
for a long period of time, please remove the
AC adapter to reduce energy consumption.

2

Cassette slot

● Load a cassette into or unload it from the slot.

Please insert a standard DV or a mini DV cas-

sette. (

☞ Page 30)

● When the unit is in the OPERATE OFF state

and if a cassette is loaded, it goes into the
ON state.

3

[A. DUB] Audio dubbing button/LED

● Press this button for audio dubbing (after-re-

cording).
For audio dubbing, set the AUDIO MODE item
of the AUDIO/VIDEO menu to “32K”.
Sound produced by the

6

MIC terminal or

the

9

AUDIO IN terminal at the rear panel

(

☞ Page 15) is recorded on CH3 and CH4

channels.

● During audio dubbing, the A. DUB LED lights

up red.

● If the INPUT SEL. switch is set at “DV”, audio

dubbing is not possible.

(

☞ Page 39, “Audio dubbing”)

4

[INPUT SEL.] Input video signal se-
lection switch

● Select the video signal input with this switch.

Y/C

: YC separate video signals from the Y/

C IN terminal

LINE : composite video signals from the LINE

IN terminal

DV

: DV signals from the DV IN/OUT termi-

nal (IEEE1394)

Note

During recording, manipulating this switch will
not bring about any effect.

NAMES AND FUNCTIONS
OF VARIOUS PARTS

Front panel

BR-DV3000_E_p03-49

06.8.24, 1:37 PM

10

Advertising