JVC BR-DV600AE - Manual (Page 40)

E-40
RECORDING
–
Backup recording function
–
By linking this unit to other DV devices, this unit can perform continuous, long-hour recording.
This unit can be set as a backup unit connected to a DV camcorder (GY-DV300/DV500/DV550/
DV5000, etc.). When the recording tape of the source unit ends, this unit can start recording.
This enables long-hour recording.
Mini
PROFESSIONAL
SET
MENIU
EJECT
REC PLAY PAUSE
REW STOP FF
DVCAM NTSC PAL REC INH.
CH-1/3
CH-2/4
BR-DV3000
A.DUB
OPERATE
INPUT SEL. REMOTE SEL. MIC
SERIAL
WIRELESS 9PIN
LINE
DV Y/C
INPUT SEL. switch
Backup unit: the main unit
LIGHT ON OFF
COUNTER
CTL TC
UB
RESET OPERATE/WARNING
MONITOR SELECT
STATUS SHUTTER
MENU
FILTER 1 3200k
2 5600k
3 5600k+ND
POWER NG
GAIN OUTPUT WHT.BAL VTR
ON OFF
ALARM
MONITOR
S A V E S T B Y H M L B A R S C A M A U T O K N E E P R S T A B O N O F F
CH-1 CH-2 AUDIO
LEVEL AUTO IRIS LOLUX BACK L NORMAL
SPOT L STRETCH NORMAL
COMPRESS FULL AUTO BLACK
DV cable
DV terminal DV terminal
Memo
• Backup recording records the video and sound
from the source unit to the main unit.
While this unit is performing backup record-
ing, please continue shooting from the source
unit.
• The audio mode is the mode configured in the
source unit. (32K/48K)
• Please set the BACKUP REC TIME item to
“OFF” if the unit is not performing backup re-
cording.
Connection
Connect the DV terminal of the source unit to the
DV terminal of this unit with a DV cable.
Setting up this unit
Ⅵ Set the INPUT SEL. switch on the front
panel to “DV”.
Ⅵ Set the BACKUP REC TIME item of the
SYSTEM (1/2) menu.
Use the following settings according to the length
of the tape of the source unit.
For DV or mini DV cassettes:
25MIN
: 30-minute tape
55MIN : 60-minute tape
75MIN : 80-minute tape
115MIN : 120-minute tape
175MIN : 180-minute tape
265MIN : 270-minute tape
OFF : No backup recording
Ⅵ Set the TC DUPLICATE item of the TIME
CODE menu to “OFF”.
• It records the data of the built-in time code
generator or the built-in clock.
• When the TC DUPLICATE menu item is set to
“AUTO” or “NON DROP”, the time code of the
DV camcorder will stop advancing. If the DV
cable is disconnected, the time code of the
backup recording will stop advancing.
Operation
1.
Recording begins on the source unit.
* Please record from the beginning of the re-
cording tape.
2.
This unit begins recording when the
tape of the source unit is near the end
(about 5 minutes before the end of the
tape).
• This unit begins recording when the record-
ing time of the source unit reaches the time
configured by the BACKUP REC TIME set-
ting.
BR-DV3000_E_p03-49 06.8.24, 1:38 PM 40