JVC FSSD1000CA - Manual (Page 30)

G-1
Warnings, Cautions and Others
Caution — % % % % switch!
Disconnect the mains plug to shut the power off completely.
The
% % % % switch in any position does not disconnect the mains
line. The power can be remote controlled.
CAUTION
To reduce the risk of electrical shocks, fire, etc.:
1 Do not remove screws, covers or cabinet.
2 Do not expose this appliance to rain or moisture.
CAUTION
1.
Do not block the ventilation openings or holes.
(If the ventilation openings or holes are blocked by
a newspaper or cloth, etc., the heat may not be
able to get out.)
2. Do not place any naked flame sources, such as
lighted candles, on the apparatus.
3. When discarding batteries, environmental prob-
lems must be considered and local rules or laws
governing the disposal of these batteries must be
followed strictly.
4. Do not use this apparatus in a bathroom or places
with water. Also do not place any containers filled
with water or liquids (such as cosmetics or medi-
cines, flower vases, potted plants, cups, etc.) on
top of this apparatus.
Caution: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage,
locate the apparatus as follows:
1 Front: No obstructions and open spacing.
2 Sides/ Top/ Back:No obstructions should be placed in the
areas shown by the dimensions below.
3 Bottom:Place on the level surface. Maintain an adequate
air path for ventilation by placing on a stand with a height of
10 cm or more.
IMPORTANT FOR LASER PRODUCTS
REPRODUCTION OF LABELS
1 CLASSIFICATION LABEL, PLACED ON EXTERIOR SURFACE
2 WARNING LABEL, PLACED INSIDE THE UNIT
1 CLASS 1 LASER PRODUCT
2 CAUTION: Invisible laser radiation when open and inter-
lock failed or defeated. Avoid direct exposure to beam.
3 CAUTION: Do not open the top cover. There are no user
serviceable parts inside the Unit; leave all servicing to qual-
ified service personnel.
CAUTION
■ ■ ■ ■ About the Internal Cooling Fan
This unit (CA-FSSD1000) includes an internal cooling fan, so as to allow for high-power operation within a small space.
This fan comes on when the sound level is set high, and may also come on even at low sound levels if the internal temperature rises. To
ensure effective fan operation, please leave at least 15cm clearance between the rear of the unit and the wall, and at least 1cm clearance
on each side of the unit.
CLASS 1
LASER PRODUCT
1 cm
STANDBY/ON OPEN/CLOSE
PHONES
1 cm
15 cm
15 cm
20 cm
20 cm
15 cm 15 cm
Front view Side view
CA-FSSD1000
CA-FSSD1000
SP-PW1000 SP-PW1000
FS-SD1000_01E.book Page 1 Thursday, March 29, 2001 1:27 PM