Jwin JC-CD160 - Manual (Page 4)

-- 6 -- -- 7 --
1
7
4
2 5
3
1. Dashboard
2. Nut (5mm)
3. Spring washer
4.
Screw (5 x 16mm)
5. Screw
6. Strap
Be sure to use the strap to secure the
back of the unit of the place. The strap
can be bent by hand to the desired
angle.
7. Plain washer
1. Frame
2. Insert fingers into the groove in the front
of frame and pull out to remove the
frame .(When re-attaching the frame.
Point the side with a groove downwards
and attach it.)
3. Lever
Insert the levers supplied with the unit
into the grooves at both sides of the unit
as shown in figure until they click.
Pulling the levers makes it possible to
remove the unit from the dashboard.
3
1
6
4 SPEAKER WIRING 4 SPEAKER WIRING
CONNECTIONS
ANTENNA
FRONT
LEFT
SPEAKER
REAR
LEFT
SPEAKER
FRONT
RIGHT
SPEAKER
REAR
RIGHT
SPEAKER
+ WHITE
- WHITE/BLACK
+ GREEN/BLACK
- GREEN
VIOLET +
VIOLET/BLACK-
GRAY +
GRAY/BLACK-
RED(R)
WHITE(L)
RED(R)
WHITE(L) 7A
1A
0.5A
FUSE
YELLOW
BACK UP
RED
B (+)
BLUE
AUTO ANT(+)
BLACK
GROUND(-)
LINE OUT
LINE IN
GRAY
BLACK
DIN FRONT- MOUNT (Method A)
Installing the unit
1. Dashboard
2. Holder
After inserting the holder into the
dashboard, select the appropriate tab
according to the thickness of the
dashboard material and bend them
inwards to secure the holder in place.
3. Screw
1
3
2
USING THE RESET BUTTON
FLASHING
Press button with a thin, pointed object if unit is malfonctioning. Though not a normal
occurrence, the microprocessor which controls the operation of this unit can be affected
by electrostatic noise.
This generally is indicated by such symptoms as no power being supplied when you switch
the unit on, failure of buttons and controls, or an abnormal display.
Should this happen, press the reset button with a thin, pointed object to reset the
microprocessor.
SPECIFICATIONS
FM SECTION
MW(AM) SECTION
Frequency Range : 87.5-107.9 MHz
Frequency Range : 530 - 1710 KHz
Channel Step : 200 Khz
Channel Step : 10 KHz
Intermediate Frequency : 10.7 MHz
Intermediate Frequency : 450 KHz
Usable Sensitivity : 33 dB
Image Rejection Ratio at 106KHz : >50 dB
Image Rejection Ratio : >50 dB
Signal to noise ratio : >60 dB
If Rejection Ratio : >50 dB
CD PLAYER SECTION
Signal to noise Radio : More than 60dB
Channel separation : More than 60dB
Frequency Response : 20Hz - 20KHz
GENERAL
Power Supply Voltage : DC 12 Volts Negative Ground
Speaker impedance : 4 - 8
Maximum Output Power : 15W x 4CH
Dimensions Chassis : 178(W) x 50 (H) x 160(D)mm
RESET