JVC HR-XV1EK - Manual (Page 27)

27
PLUSCODE NO.
DATE
START
END
CH
SPEED
PDC 15 FRI
17:30
18:00
3
SP
OFF
SELECT
SET
EXIT
:
:
: MENU
57378
OK : OK
Look up the PlusCode Number in an
appropriate TV programme magazine.
Select the desired TV programme for
recording and refer to the PlusCode
Number next to it.
VIDEO Plus+ ® Recording
Preparation
• Turn on the TV and select the VCR channel on TV.
• Make sure TV/VCR/DVD switch has been slided to VCR/
DVD. Then press VCR to select the VCR mode. (The VCR
indicator will light)
1
Press PROG..
2
Enter the PlusCode
Number using number
keys.
3
Note: If any button is not
pressed within 60 seconds,
the Recorder switches
back to TV operation.
• In case of an error, press
CANCEL and enter the
desired number again.
Press ▲ or ▼ to select ONCE, DAILY or WEEKLY.
PLUSCODE NO.
ONCE
DAILY
WEEKLY
PLUSCODE
SELECT
CLEAR
OK
EXIT
: CANCEL
:
: 0–9
: OK
: PROG.
NO.
PLUSCODE NO.
ONCE
DAILY
WEEKLY
PLUSCODE
SELECT
CLEAR
OK
EXIT
: CANCEL
57378
:
: 0–9
: OK
: PROG.
NO.
4
Press OK. By the PlusCode Number, the entered data
• If the entered Number
is not correct, the
indicator "PLUS CODE
ERROR" will appear.
Enter the correct number.
appears on the screen.
Select your tape speed.
PLUSCODE NO.
ONCE
DAILY
WEEKLY
PLUSCODE
SELECT
CLEAR
OK
EXIT
: CANCEL
57378
:
: 0–9
: OK
: PROG.
NO.
ONCE = To record a
programme only once
DAILY = To record TV
programmes transmitted
daily
WEEKLY = To record TV
programmes transmitted
once a week.
VIDEO Plus+ and PlusCode are
registered trademarks of Gemstar Development Corporation.
The VIDEO Plus+ system is manufactured under license
from Gemstar Development Corporation.
Note:
• The built-in timer stores 8 memories. If
the "PROGRAM FULL" indication
appears, you must delete one memory
(see page 31).
• When the power supply is interrupted
for more than 30 minutes, the preset
programme is cleared. In this case,
you have to set the timer again.
2A77501B E(24-29) 5/30/02, 9:22 PM 27