Jaguar VOICE ACTIVATION X-TYPE 2001.5 - Manual (Page 33)

30 Voice activation
Voice training
The voice activation system is able to interpret most English
speakers without difficulty. If, however, it is found that
commands are sometimes not being recognized, the voice
system can be trained to improve its recognition of the user. The
voice system can be trained for two users using voice memories
A and B. After voice training, the system will automatically
recognize a user whose voice is held in the voice memory. The
system can still be used by other users, with no loss of
recognition.
Training procedure
The procedure for training a voice is as follows:
Vehicles fitted with navigation system:
1. First, select which voice memory to train. To check which
memories are already in use, use the VOICE DIRECTORY
command. This will list the memories used and, if stored with
a nametag, the names of the users stored. If no memories are
in use, either memory can be used. If both memories are in
use and you wish to overwrite one of the memories select the
memory you wish to overwrite.
2. Position the vehicle, with the sunroof and windows closed, in
a reasonably quiet outdoor location.
3. Sit in the driving seat with the engine running, the handbrake
on and the transmission in Park or Neutral.
4. Press the MENU button adjacent to the display screen. Press
"System Setup" on the Menu screen and press the "Voice
training" button on the System Setup screen to reveal the
Voice Training screen (see illustration above). On the Voice
Training screen you will have to select which memory
location you wish to use (A or B).
5. After the instructions press and release the voice button to
start training. If you have chosen to overwrite an existing
memory by mistake and would like to cancel press and hold
the voice button for 5 seconds.