JVC HR-XVS44UJ - Manual (Page 32)

Filename [XVS44UJ_07S-VHS.fm]
Masterpage:Left+
32
EN
Page 32 27 August 2003 12:31 pm
OPERATIONS ON VCR DECK (cont.)
Elapsed Recording Time Indication
1 Set the counter display.
Press DISPLAY until a counter reading appears on the
front display panel.
2 Reset the counter.
Press C.RESET before starting recording or playback.
● The counter is reset to “0:00:00” and shows the exact elapsed
time as the tape runs. You can check the exact time of a
recording or playback.
Tape Remaining Time
Press DISPLAY until the time remaining on the tape
appears.
● The front display panel shows the tape remaining time with
“z” displayed.
● By pressing the DISPLAY button, you can change display to
show the clock time, counter reading or tape remaining time.
NOTES:
● When you press DISPLAY, the on-screen display appears on
the TV screen for 5 seconds, then the displays other than the
counter disappears. To clear the counter display, press
DISPLAY.
● Depending on the type of tape being used, the tape remaining
time reading may not appear right away, or is not correct.
“– –:– –” may sometimes appear, or the display may blink on
occasion.
Second Audio Recording
This unit’s built-in MTS decoder enables reception of
Multichannel TV Sound broadcast. To record a SAP program
received, set “2ND AUDIO RECORD” to “ON”. (
੬
pg. 76)
NOTE:
When the channel is changed on the unit;
● The “STEREO” indicator appears on the screen for about
5 seconds if the program is a stereo broadcast.
● The “SAP” indicator appears on the screen for about 5 seconds
if the program is a SAP broadcast.
● Both indicators appear when a stereo program is accompanied
by SAP sound.
XVS44UJ_01.book Page 32 Wednesday, August 27, 2003 2:01 PM