JVC HR-XVS44UJ - Manual (Page 67)

Masterpage:Right-No-Heading
EN
67
Filename [XVS44UJ_09Editing.fm]
Page 67 27 August 2003 2:00 pm
Edit To Or From
Another Video
Recorder
You can use your unit as the source player or as the
recording deck.
A
Make connections.
A When using your unit as the source player ...
... connect its AUDIO/VIDEO OUTPUT connectors to the
audio/video input connectors on another recorder.
B When using your unit as the recording deck ...
... connect its AUDIO/VIDEO INPUT connectors to the
audio/video output connectors on another recorder.
● If connecting a unit with an S-VIDEO input/output connector,
it is recommended to use the supplied S-Video cable to
minimize picture degradation while editing.
B
Select the VCR deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the Remote
Press VCR so that the VCR indicator lights up.
C
Set the input mode of recording deck.
With this video unit, press AUX (number key “0”) and/or
CH to select “L-1”.
● When using S VIDEO connector, set “REAR AUX INPUT” to
“S-VIDEO”. (
੬
pg. 77)
● When using VIDEO connector, set “REAR AUX INPUT” to
“VIDEO”. (
੬
pg. 77)
● When using another recorder as the recording deck, refer to its
instruction manual.
D
Set the edit mode.
See “PICTURE CONTROL” on page 74.
E
Engage the Record Pause mode of the
recording deck.
Locate the point where you start recording, then engage
the Record Pause mode.
F
Start the source player.
Engage the Play mode of the source player.
G
Start the recording deck.
Engage the Record mode of the recording deck.
NOTES:
● All necessary cables can be obtained from your dealer.
● When you select “EDIT” to dub tapes in step D, be sure to
select “AUTO” (or “NORM” when “VIDEO CALIBRATION” is
set to “OFF”) after you finish dubbing the tapes.
● When you use this unit as the source player for editing, be sure
to set “SUPERIMPOSE” to “OFF” before starting. (
੬
pg. 75)
Advantages of S-VHS video recorders
You can edit from VHS to S-VHS, S-VHS to VHS, or, from
S-VHS to S-VHS.
● From VHS to S-VHS: Record VHS playback signals in the
S-VHS mode. Although the picture quality is inherently
limited by that of the original, the edited tape has better
picture quality than those made by VHS-to-VHS editing.
● From S-VHS to VHS: Because the picture quality of the
source material is very high, the edited tape has better
picture quality than those made by VHS-to-VHS editing.
● From S-VHS to S-VHS: All signals will be transferred with
minimum degradation.
A
B
AV mode
Audio/video
cable
Recorder
Your unit
Another recorder
Player TV receiver
Audio/video cable
AV mode
TV receiver
Another recorder
Player
Your unit Recorder
Audio/video
cable
Audio/video
cable
S-Video cable
S-Video cable
Slide the TV/VCR/DVD switch to the right.
XVS44UJ_01.book Page 67 Wednesday, August 27, 2003 2:01 PM