JVC XV-N44SL - Manual (Page 36)

Additional information
34
XV-N44SL/GNT0032-001A/English
A
d
d
itional
info
rmat
ion
Troubleshooting
Power
Power does not come on.
\ Power plug is not inserted securely. Plug in securely.
Operation
“REGION CODE ERROR!” is shown on the TV screen.
\ Region code of the inserted disc does not match the unit.
Check the region code of the disc printed on the disc jacket.
Operation is not possible.
\ Microcomputer malfunction due to lightning or static electricity.
Turn off the power and unplug the power cord, then connect
the power cord again.
\ Moisture condensation caused by a sudden change of
temperature or humidity. Turn off the power, then turn it on a
few hours later.
\ The disc does not allow the operation, or an unplayable disc is
inserted. Check and replace the disc (see page 2).
[LOCK] is displayed on the display window and the disc tray
does not open.
\ When you press 0 while pressing down 7 on the unit in
standby mode, the tray lock function is activated. The disc tray
cannot be opened or closed in this status. To release this
status, press
0 while pressing down 7 on the unit in standby
mode.
Picture
Picture is noisy.
\ The unit is connected to a VCR directly and the copyguard
function is activated. Connect the unit so that the picture
signal flows directly to the TV.
\ With some discs, the picture may be blurred when [PICTURE
SOURCE] is set to [FILM] or [AUTO]. Set [PICTURE
SOURCE] to [VIDEO (NORMAL)] or [VIDEO (ACTIVE)].
Picture is distorted when using COMPONENT VIDEO OUT or
S-VIDEO output jack(s).
\ Both the component connection and S-video connection are
made. Disconnect the unused one.
No picture is displayed on the TV screen or the screen is
blurred or divided into two parts.
\ The unit is in the progressive scanning mode though it is
connected to a TV via the VIDEO or S-VIDEO jack. Set the
VIDEO SIGNAL SELECTOR on the rear panel to “480i,” or set
it to “REMOTE” and make the Progressive scanning mode
inactive by using the VFP - PROGRESSIVE SCAN button
(see page 4).
Audio
DVD VIDEO disc playback sound level is lower than TV
broadcast sound level.
\ Set the [D.RANGE CONTROL] preference to [TV MODE] (see
page 28).
Analog audio output is distorted.
\ Set the [OUTPUT LEVEL] preference to [LOW] (see page 28).
Sound is abnormal when DTS-encoded source is played
back.
\ Connect audio equipment with a built-in DTS decoder to the
unit.
\ Play back a source other than DTS-encoded one.
MP3
No sound comes out.
\ MP3 disc is recorded with the “packet writing (UDF format)” It
cannot be played.
Files (tracks) are not played in the recorded order.
\ This unit plays the files in the alphabetic order. So, the
playback order can vary.
Specifications
Specifications and appearance are subject to change without
prior notice.
General
Readable discs DVD VIDEO, DVD-R (Video format), DVD-
RW (Video format), +RW (Video format),
SVCD, Video CD, Audio CD (CD-DA), MP3
format, JPEG, CD-R/RW (CD-DA, SVCD,
Video CD, MP3 format, JPEG)
Video format NTSC, 480i (Interlaced scan)/480p
(Progressive scan) selectable
Other
Power requirements
AC 110 V-240 V Ó, 50 Hz/60 Hz
Power consumption
10 W (POWER ON), 0.7 W (STANDBY
mode)
Mass 2.1 kg (4.7 lbs)
Dimensions (W × H × D)
435 mm × 53 mm × 248.4 mm
(17- 3 / 16 inch × 2- 1 / 8 inch × 9- 13 / 16 inch)
Video outputs
COMPONENT (pin jacks)
Y Output: 1.0 Vp-p (75 Ω)
P B /P R Output: 0.7 Vp-p (75 Ω)
VIDEO OUT (pin jack)
1.0 Vp-p (75 Ω)
S-VIDEO OUT (S jack)
Y Output: 1.0 Vp-p (75 Ω)
C Output: 286 mVp-p (75 Ω)
Horizontal resolution
500 lines or more
Audio outputs
ANALOG OUT (pin jack)
2.0 Vrms (10 k Ω)
DIGITAL OUT (COAXIAL)
0.5 Vp-p (75 Ω termination)
DIGITAL OUT (OPTICAL)
–21 dBm to –15 dBm (peak)
Audio characteristics
Frequency response
CD (sampling frequency 44.1 kHz):
2 Hz to 20 kHz
DVD (sampling frequency 48 kHz):
2 Hz to 22 kHz
(4 Hz to 20 kHz for DTS and Dolby
Digital bitstream signals)
DVD (sampling frequency 96 kHz)
2 Hz to 44 kHz
Dynamic range 16 bit: More than 98 dB
20 bit: More than 100 dB
24 bit: More than 100 dB
Wow and flutter Unmeasurable (less than + 0.002%)
Total harmonic distortion
less than 0.006%
• Manufactured under license from Dolby Laboratories. “Dolby”
and the double-D symbol are trademarkes of Dolby
Laboratories.
• Manufactured under license from Digital Theater Systems, Inc.
“DTS” and “DTS Digital Surround” are registered trademarks of
Digital Theater Systems, Inc.
XV-N44SLL(UJ).book Page 34 Monday, March 3, 2003 6:03 PM