JVC SP-THA25 - Manual (Page 37)

33
Using Preset Tuning
Once a station is assigned to a channel number, the station can be
quickly tuned. You can preset up to 30 FM and 15 AM stations.
To store the preset stations
From the remote control ONLY:
1
Tune in the station you want to preset (see
“Tuning in Stations”).
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
2 again.
2
Press MEMORY.
The preset number appears on the display and the
PRGM (program) indicator flashes.
3
Press ¢ or 4 to select a preset
number.
• Press and hold ¢ or 4 to change the preset
number continuously.
4
Press MEMORY to store the preset station.
The PRGM indicator goes off, and the station is
assigned to the selected preset number.
5
Repeat steps 1 to 4 until you store all the stations
you want.
To erase a stored preset station
Storing a new station on a used number erases the previously stored
one.
To tune in a preset station
From the remote control:
1
Press FM/AM repeatedly to select the
band.
The last received station of the selected band is tuned
in.
• Each time you press the button, the band alternates between
FM and AM.
2
Press ¢ or 4 repeatedly until the
desired preset station appears on the
display.
• ¢: Increases the preset number.
• 4: Decreases the preset number.
• Press and hold ¢ or 4 to change the preset number
continuously.
On the front panel:
1
Press SOURCE repeatedly until the
desired band appears on the display.
2
Press 7 so that “PRESET” appears on the
display.
• Each time you press the button, the operation mode of
¢ and 4 buttons alternates between “PRESET” and
“MANUAL.”
PRESET: Select this for using ¢ and 4 as the
buttons to select the preset station.
MANUAL: Select this for using ¢ and 4 as the
buttons to change the frequency manually.
3
Press
¢ or 4 repeatedly until
the desired preset station appears on
the display.
• ¢: Increases the preset number.
• 4: Decreases the preset number.
• Press and hold ¢ or 4 to change the preset number
continuously.
Selecting the FM Reception Mode
When an stereo FM program tuned currently is noisy, you can
change the FM reception mode to improve the reception.
From the remote control ONLY:
Press FM MODE.
The
indicator goes off from the display and the
program loses the stereo effect.
To resume the stereo effect, press FM MODE again.
The stereo effect resumes.
Notes:
Be sure to change the FM reception mode to stereo when you change
a station.
MHz
TUNED ST
L R
SW
MEMORY
MEMORY
FM/AM
SOURCE
FM MODE
REPEAT
MHz
PRGM TUNED ST
L R
SW
Preset number
32_36_TH_A25[B].p65 03.7.28, 8:07 PM 33