Troubleshooting, Troubleshooting roubleshooting – JVC HR-XVC19SUS User Manual
Page 36
36
T
T
roubleshooting
roubleshooting
Symptom
No power.
The power is on, but
the DVD+VCR does
not work.
No picture.
No sound.
The playback picture
is poor.
The “PROGRESSIVE
SCAN MODE”
message remains to
be displayed.
Cause
z
The power cord is disconnected.
z
DVD or VCR button is not switched
properly.
z
No disc is inserted.
z
No tape is inserted.
z
The TV is not set to receive DVD +
VCR signal output.
z
The video cable is not connected
securely.
z
Wrong connection.
z
The equipment connected with the
audio cable is not set to receive
DVD+VCR signal output.
z
The audio cables are not connected
securely.
z
The power of the equipment connect-
ed with the audio cable is turned off.
z
The AUDIO options are set to the
wrong position.
z
The disc is dirty.
z
The TV channels are not tuned in
properly.
z
Tape heads are dirty.
z
Tape is a rental or was recorded on
another VCR.
z
This unit can only output 525p
Progressive scan picture.
z
DVD+VCR was turned off while set-
ting the Progressive scan mode.
z
The Progressive Scan is set to On on
the setup menu but is connected to a
standard(analog) television with com-
ponent video input.
Correction
z
Plug the power cord into the wall
outlet securely.
z
Refer to page 7.
z
Insert a disc or tape. (Check that
the disc or tape indicator in the dis-
play window is lit.)
z
Select the appropriate video input
mode on the TV so the picture from
the DVD+VCR player appears on
the TV screen.
z
Connect the video cable into the
jacks securely.
z
Check the connection.
z
Select the correct input mode of
the audio receiver so you can listen
to the sound from the DVD+VCR.
z
Connect the audio cable into the
jacks securely.
z
Turn on the equipment connected
with the audio cable.
z
Set the AUDIO options to the cor-
rect position.
z
Clean the disc.
z
Check tuning, carry out tuning
again.
z
Clean video heads.
z
Use CH -/+ for manual tracking
adjustment while tape is playing.
z
Make sure that your TV can sup-
port 525p Progressive scan picture
or set Progressive scan to off.
z
Keep pressing STOP (
x) for more
than 5 seconds.
Check the following guide for the possible cause of a problem before contacting service.