Reference – JVC HR-XVC19SUS User Manual
Page 37
37
Reference
Symptom
The DVD+VCR does
not start playback.
Video tape cannot be
inserted.
No Hi-Fi sound
The Remote Control
does not work
properly.
Camcorder image is
not shown.
Camcorder image via
AV input to
DVD+VCR is not
shown on TV screen.
Timer recording is not
possible.
Cause
z
An unplayable disc is inserted.
z
The disc is placed upside down.
z
The disc is not placed within the
guide.
z
The disc is dirty.
z
Is the cassette compartment
empty?
z
Audio mode is not set properly.
z
There is an obstacle in the path of
the Remote Control and this unit.
z
The batteries in the Remote Control
are exhausted.
z
The Remote Control is not pointed
at the remote sensor of the
DVD+VCR.
z
The Remote Control is too far from
the DVD+VCR.
z
This Remote Control use the same
buttons for VCR and DVD functions
(ex.PLAY).
z
The Remote Control of a JVC TV or
Receiver cannot operate the DVD+
VCR.
z
Camcorder is off.
z
DVD+VCR SOURCE SELECT is
not set to LINE1 or LINE2.
z
Clock in DVD+VCR is not set to
correct time.
z
Timer has been programmed
incorrectly.
z
indicator light does not appear
after programming timer.
Correction
z
Insert a playable disc. (Check the
disc type and Regional code.)
z
Place the disc with the playback side
down.
z
Place the disc on the disc tray cor-
rectly inside the guide.
z
Clean the disc.
z
Eject the tape in.
z
Select STEREO by repeatedly
pressing A.MONITOR on the
Remote Control.
z
Remove the obstacle.
z
Replace the batteries with new ones.
z
Point the Remote Control at the
remote sensor of the DVD+VCR.
z
Operate the Remote Control within
23ft (7m).
z
When using a VCR, first press the
VCR button. When using a DVD, first
press the DVD button.
z
Use the DVD+VCR’s Remote
Control.
z
Turn camcorder on and operate
properly.
z
Press AUX to select LINE input
channel (LINE1 or LINE2).
z
Set clock to correct time.
z
Reprogram Timer.
z
Reprogram Timer and turn
DVD+VCR off to enable timer.