JVC HR-XVC19SUS - Manual (Page 11)

11
Preparation
Connecting an Connecting an Antenna Antenna
or Cable TV or Cable TV
a Antenna:
Disconnect the antenna from the rear of the TV
and identify the antenna cable. If it is a round 75
ohm coaxial cable connect it directly to the jack
marked ANT.IN on your DVD+VCR. If your anten-
na cable is flat connect it to a 300-ohm to 75-ohm
antenna adaptor (not supplied) and slip the adap-
tor over the ANT.IN jack. Don’t attempt to screw it
into to the DVD+VCR.
b Cable TV:
If your cable connection has no converter or
descrambler, unscrew the cable from your TV and
attach it to the ANT.IN jack on the DVD+VCR. If a
converter is required connect a coaxial cable from
the wall jack to the IN connector on the converter,
and a coaxial cable from the OUT connector on
the converter to the ANT IN on your DVD+VCR.
This cable hookup permits both TV and
DVD+VCR operation.
To view or record a CATV channel when
using cable box
1. Tune the TV to the DVD+VCR output channel
(CH 3 or 4).
2. Set the DVD+VCR channel selector to the
cable output channel. (Example: CH3)
3. Select a channel using the cable converter.
Notes:
• With this connection, you cannot record one pro-
gram while viewing another.
• If you are using a cable box to tune channels, it is
not necessary to do Auto Channel Set.
Basic TV Connections Basic TV Connections
Make one of the following connections, depending
on the capabilities of your TV.
Rear of DVD+VCR
Antenna Antenna
OR OR
Rear of DVD+VCR
L R
AUDIO INPUT VIDEO INPUT
ANTENNA
INPUT
Rear of TV
A1 V R
Y Pb Pr
COMPONENT/PROGRESSIVE SCAN
VIDEO INPUT
L R
AUDIO INPUT
Rear of TV
A2 C