Jwin JX-CD915 - Manual (Page 3)

— 5 — — 6 — — 7 —
• If FM signal is too weak, may cause big noise for stereo stations, please set the function
switch to FM MO. position.
BBS (BASS BOOST SYSTEM) FUNCTION
Set the BBS button to ON position to enhance the bass effect.
PRESET EQUALIZER FUNCTION
Press the EQ button activates 4 Kinds of sound effect as follows:
CLASSIC ROCK JAZZ POP
* The EQ indicator will appear on the display.
MAINTENANCE
Cleaning the Lens
If the lens becomes dusty, clean it with camera lens blower. Be careful not to scratch the
surface of the lens.
Cleaning the Cabinet
From time to time, clean the cabinet with a soft dry cloth. For more stubborn stains, slightly
moisten the cloth with water or a mild detergent solution. Never use benzene, alcohol or
other solvents as they may damage the finish of the cabinet.
SPECIFICATIONS
C D :
Output Power : 20MW (32 )
Freq. Response : 100 ~ 20000 Hz
RADIO:
Frequency range
: FM 88 - 108MHz
Output Power : 20MW (32 )
Power Source : 2 x UM-3 or AA size batteries
4.5V (600mA) AC - DC adaptor
Dimensions : 142mm(W) x 142mm(D) x 32mm(H)
** For improvement purposes, specification and design are subject to change without
notice. **
PROGRAM PLAY (FOR MP3 DISC)
1. In stop mode, press the MODE/PROG button to make program memory.
2. “ PGM 0P-01 0 ” will be displayed. “ 0 ” means DIRECTORY number, “ 0 ” means file
number, “P-01” means program number.
* “ 0 ” flashing appears on the display.
3. Press the ASP/DIR button to select the desired directory.
4. Press
or button to select the desired file.
5. Press the MODE/PROG button to enter the DIRECTORY and file into memory.
The program number which will be increment one step.
* The program no.“P-01” has become “P-02” on display.
6. Repeat step 3 to 5 until memory is full (UP TO 60 FILES).
7. Press
button to start the program play.
8. To stop the program play, press the STOP button.
9. For program play in step “ 8 “, press the MODE/PROG button &
button.
10. To erase the program memory, turn off the power or open the door.
* If you do not neet to select directory, only select files, the above step 3 can pass.
DIGITAL ANTI-SHOCK OPERATION
The DIGITAL ANTI-SHOCK PROTECTION function uses semiconductor memory to pre-
vent the second from skipping when the unit is subjected to shocks and vibration during play.
When the PLAY/PAUSE button is pressed and the power turns on, the “ASP” appear and the
digital Anti-Shock Protection function turns on automatically.
It will give approximately 40 seconds(MP3 120 seconds) of protection against interruption
of sound output, if the player is subjected to shocks of more than 40 seconds duration, some
interruption of sound output will occur, this is normal and to be expected, the sound will
resume once the player has stabilized from the shock.
• To turn this function off, press ASP/DIR button once, the ASP indicator will disappear.
(FOR CD DISC ONLY)
• In MP3 disc always has the ASP function and the ASP time is 120 seconds at 128 Kbps
bit rate.
RADIO OPERATION
Perform the following in sequence:
1. Insert the headphone/earphone plug to PHONE JACK.
2. Set the FUNCTION SWITCH to the FM ST. position.
3. Turn the TUNING KNOB in the desired radio station.
4. Adjust the VOLUME CONTROL.
5. To turn the radio off, set the FUNCTION SWITCH to CD position.
Notes :
• When listening to FM program, the phone cord works as an antenna. To insure maximum
tuner sensitivity, keep the phone cord (antenna) always straight. Do not fold it.
• Reception sensitivity depends on the placement of the phone cord. Try to determine the
cord position which provides the best sensitivity.
TROUBLE SHOOTING GUIDE
Cleaning the Disc
When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the center out.
Note - Do not use solvents such as benzine, thinner, commercially available cleaners
or anti-static spray intended for analogue discs.
** Should you experience difficulties in the use of this player please refer to the
following chart before contacting your dealer or the place of purchase.
Troubleshooting Guide
Problem Points to check
Player fails to function - The disc may be inserted upside down.
- The disc not mounted correctly on the chuck.
- Dirty or a defective disc.
- Dirty pick up lens.
- Player lid not closed.
- Moisture condensation, allow the player to warm up to
room temperature for 60 minutes.
- AC Power to an adaptor switched off.
- Auto power off has occurred, press PLAY button to
restore power.
- Weak batteries.
- Hold switches at ON position, switch to OFF position.
No sound from Earphones - Earphones' plug is not firmly inserted into the Phones
socket.
- VOLUME set on min. position.
Intermittent Sound - Dirty or defective disc.
- Dirty pick up lens.
- The player is subject to excessive vibration or shock.
- Low battery power.
- Poor Earphone connection.