JVC WB-1550 - Manual (Page 14)

14
Installation and Connection (WB-1550)
4.
Open the cable connection cover
Use provided hexagon wrench to remove the 4 screws
(M3 x 12) from the cable connection cover to open it.
5.
Connect each cable
Connect the necessary cables.
6.
Bind cable using a waterproof tape
Upon connecting, ensure to perform waterproofing
procedures by binding the joint of each cable with a
waterproof (adhesive) tape.
7.
Fasten the cables in the interior of the arm
When waterproofing is complete, insert the cables into the
upper interior of the arm and fasten using a tape.
8.
Cover the hole and the mounting side of
housing with waterproof seal.
After the cables have been connected, cover the holes made
in step 1. with waterproof seal. With the Cable connection
cover open, put your hand in and cover the hole. Cover the
mounting side of the housing with waterproof seal.
9.
Close the cable connection cover
When cable connection is complete, close the cable
connection cover and fasten the 4 screws (M3 x 12)
removed in step 4. using the provided hexagon wrench.
Mounting the Housing to the Wall (continued)
4.
9.
5.
6.
7.
8.
8.
Alarm/Communication Cable
Coaxial Video Cable
AC 24 V
Power Cable
LAN Cable (Male)
Screw (M3 x 12) x 4
Bind using a waterproof
(adhesive) tape
Bind with insulating tape
T
Not in use on this system.
T
DC 12 V Power Cable
Hole
Waterproofing
Waterproofing
CAUTION:
● Ensure to bind connectors of LAN cables that are not in
use with an insulating tape before use.
● Ensure to bind the DC 12 V Power Cable that is not in use
on this system with insulating tape.
CAUTION:
For safety reasons, turn on the power only upon connecting
all cables.
CAUTION:
When inserting the cables, ensure that all cable connections
are above the cable connection cover (see dotted line in the
left diagram).
Failure to do so may cause malfunctions due to penetration
of rain water.
NOTE:
Be sure to perform waterproofing. Seepage of rainwater may
result in malfunction.