Jwin 8-Channel Quad Splitter JV-TV5020 - Manual (Page 2)

JV-TV5020 USER’S MANUAL JV-TV5020
USER’S MANUAL
8-CHANNEL QUAD SPLITTER 8-CHANNEL QUAD SPLITTER
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE
PARTS INSIDE, REFER FOR SERVICE TO QUALIFIED
SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equatorial
triangle, is intended to alert the user to the presence of un-
insulated “dangerous voltage” within the product’s enclosure
that may be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral triangle is intended
to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature
accompanying the appliance.
THE GRAPHIC SYMBOLS WITH SUPPLEMENTAL MARKING IS
APPLIED ON THE REAR SIDE OF THE SUBJECT MONITOR.
WARNING : To prevent fire or shock hazard, do not expose this appliance
to rain, water, wet locations. Do not insert any metallic object
through ventilation grilles
.
MPORTANT SAFETY INSTRUCTIONS
This video monitor equipment is provided with a polarized alternating-
current line plug (a plug having one blade wider than the other). This plug
will fit into the power outlet only one way. This is a safety feature. If you are
unable to insert the plug fully into the outlet, try reversing the plug. If the
plug should still fail to fit, contact your electrician to replace your obsolete
outlet. Do not defeat the safety purpose of the polarized plug.
6-2. Other Keys
① FREEZE : Enables selected channel freezes in QUAD mode,
FULL mode, MODE function.
② 1 ~ 8 : Enables selected channel be displayed in full screen.
③ ARROWS : Works only in the menu screen.
④ ENTER : An editing mode on the menu screen.
⑤ PAGE : PAGE A, PAGE B change function.
7. TROUBLESHOOTING
If the system does not function properly, check following points before
contacting the service center.
No Problem Possible Solutions
1 No Video
● Verify power to all pieces of equipment in
the system.
● Verify that the power switches are in the
ON position.
● Verify that the cameras are properly
hooked up.
2
Video,
But no control
● Turn the power OFF for 30 seconds and
then turn it ON again.
RISK OF ELECTRIC SHOCK DO NOT OPEN
CAUTION