Jwin 8-Channel Quad Splitter JV-TV5020 - Manual (Page 6)

JV-TV5020 USER’S MANUAL JV-TV5020
USER’S MANUAL
8-CHANNEL QUAD SPLITTER 8-CHANNEL QUAD SPLITTER
SECTION 2
3. CONNECTIONS
The following connections are located on this splitter. See Fig. 1
for connection locations. Do not plug the power supply into this
splitter until all connections are made.
FRONT VIEW
Fig. 1 (CONNECTION LOCATIONS – Front View)
Note.
(1) This splitter has 2pages (is consists of page A with channel 1~4
and page B with channel 5~8).
(2) All buttons have a different function by press button short or long.
(3) To go into the ZOOM or MENU or VCR mode, press the
corresponding button long.
(4) By pressing channel button shortly, channel moves to anther
channel where is located in the same place on different page.
(5) By pressing Quad button shortly in Quad mode, the screen moves
to anther Quad mode on different page.
(6) If you press channel button long, the screen became freeze frame.
- Place the green color character to the DWELL TIME
using the ◀ ,▶ , ▲ and the ▼ buttons, and press
the ENTER button to flash the Dwell Time and set it using
the ▲ or the ▼ buttons. Press the ENTER button again
to stop flashing the Time.
- Press the MODE/MENU button to return to the Page 2
INDIVIDUAL menu.
c. LOAD
The video signal is normally terminated by 75 ohms. But in
case the signal is distributed to a number of lines, only one of
lines is needed to be terminated by 75 ohms (1Vp-p), while
the other lines are terminated by High impedance status
(2Vp-p). The 75 ohms or the HI can be selected by pressing
the ENTER button.
5-5-3. Page 4 BUZZER Menu
Press the MODE/MENU button again, the following menu
screen will be displayed.
[ BUZZER ]
KEY BUZZER : [Y]
LOSS BUZZER : [Y]
ALARM BUZZER : OFF
ALARM TIME : OFF
EXIT
- PAGE4 -
2 3