Jet Tools JJ-6CSDX - Manual (Page 11)

11
Installing Belt Guard
Referring to Figure 6:
1. Place the belt guard (A) over the opening in the
stand.
2. Line up the holes in the stand with the holes in
the guard.
3. Attach the guard to the stand using four
1/4-20 x 1/2’ pan head machine screws (B) and
four 1/4” flat washers (C).
Installing Cutterhead Guard
1. Remove the screw from the guard post.
Referring to Figure 7:
2. Turn spring knob (B) approximately one and
one half revolutions counter-clockwise (as
viewed from the top) and hold.
3. Insert the guard post into hole in table. Make
sure that the spring inside the spring knob (B)
engages the slot in guard post.
4. Thread the screw (C) back into the guard post.
5. Check for proper operation. The cutterhead
guard (A) must return fully to the fence when
released. If guard does not return fully, pull
guard, apply more tension to the spring knob
(B) by turning it another half turn counter-
clockwise, and re-insert guard. If guard closes
too quickly and strikes fence too hard, release
some tension on the spring.
6. Insert screw (B) back into the guard post.
Installing Access Cover
Referring to Figure 8:
Install access cover (A) by placing bottom of panel
in the stand and fastening with four #5-40 x 3/8"
pan head screws and four flat washers (B).
Installing Dust Chute
Referring to Figure 8:
Attach the dust chute (C) to the base with four 1/4"
x 1/2" machine screws and four 1/4" washers (D).
Figure 6
Figure 7
Figure 8