Jet Tools JJ-6CSDX - Manual (Page 8)

8
Unpacking
Open shipping container and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Do not discard any
shipping material until the Jointer is assembled and
running properly.
Shipping Contents
Note: This unit is shipped in two cartons.
Stand Carton
1 Stand with Motor
1 Stand Cover with Mounting Hardware
1 Dust Chute with Mounting Hardware
Stand Carton
Tools Included for JJ-6CSX
1 12/14mm Open End Wrench (O)
1 8/10mm Open End Wrench (P)
1 3mm Hex Wrench (Q)
Tools Included for JJ-6CSDX
1 12/14mm Open End Wrench (O)
1 8/12mm Open End Wrench (P)
1 3mm Hex Wrench (Q)
1 4mm T-Hex Wrench
1 8mm Hex Wrench
Additional Tools Required
#1 Cross Point Screw Driver
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor. Read the instruction manual thoroughly
for assembly, maintenance and safety instructions.
Main Unit Carton
1 Bed Assembly
1 Fence Assembly
1 Cutterhead Guard (A)
1 Belt Guard (E)
1 V-Belt (D)
4 1/4-20 x 1/2 Pan Head Screws (L)
4 1/4 Flat Washers (M)
1 Lock Handle, Flat Washer, and Lock Nut for
Fence (G)
1 Fence Handle (F)
3 Lock Bolts (B)
3 3/8" Lock Washers (C)
2 Handwheel Assembly (N)
1 Can of Touch-Up Paint (H)
1 Operating Instructions and Parts Manual (J)
1 Warranty
Card
2 Push Blocks (K)
Main Unit Carton