JVC XL-FZ700BK - Manual (Page 7)

5
Bef
o
re u
sin
g for
the
fi
rst
t
ime
English
Before using for the first time
Installing the unit
Best location
Select a location which is level, dry and neither too cold
nor too hot (temperature range 5°C to 35°C). Also, avoid
dusty locations or any location subject to vibration.
If interference occurs
If this unit is placed near a tuner or a radio receiver tuned
to AM frequencies, interference may occur. If this
happens, we recommend either that you move this unit
as far as possible from the tuner or receiver or briefly
turn off the power of this unit.
Connecting to the Analog
Output Jacks
Connecting to an amplifier or receiver allows you to
listen to the sound from the speakers.
Connect the OUTPUT jacks of this unit to the line input
jacks of an amplifier or receiver with the supplied audio
cord.
Connecting to the Digital
Output Jack
It is possible to transmit a digital sound signal from this
unit directly to a MD recorder, etc.
Supplying the power
The AC power cord is supplied separately and must be
connected to the unit.
Plug the AC power cord into the
AC IN connector of
this unit and connect to the wall outlet after all
connections are complete.
(to be continued)
NOTES
• Never connect the OUTPUT jacks to the PHONO jacks
of the amplifier or receiver. This may cause damage to
the components.
• Make sure that the same channels are connected
between this unit and the amplifier or receiver: LEFT to
LEFT and RIGHT to RIGHT.
• Do not connect the power plug until all connections are
complete.
• Connect the plugs firmly. Loose connections may cause
noise or malfunction.
RIGHT LEFT
OUTPUT (SYNCHRO) COMPU LINK - 3 DIGITAL OUT OPTICAL
AC IN AC IN
RIGHT LEFT
OUTPUT
Rear panel of this unit
Audio cord
Speaker unit
Amplifier or receiver
To audio input jacks
NOTES
• Never connect the digital output cable except to the
digital input jack.
• An optical digital cord (optional) is required to make
this connection. Refer to the instruction manual of the
MD recorder, etc. for details.
To connect the AC power cord of the
main unit
NOTE
• When using the COMPU LINK Remote Control System
(see page 6), do not connect the power cord to the
SWITCHED AC OUTLET of an amplifier or receiver.
RIGHT LEFT
OUTPUT (SYNCHRO) COMPU LINK - 3 DIGITAL OUT OPTICAL
AC IN AC IN
Rear panel of this unit
Optical digital cord (optional)
MD recorder, etc.
DIGITAL OUT
(OPTICAL)
To digital input jacks
RIGHT LEFT
OUTPUT (SYNCHRO) COMPU LINK - 3 DIGITAL OUT
OPTICAL
AC IN AC IN
AC IN connector
Rear panel of this unit
Supplied AC power cord
To the wall outlet
XL-FZ 700BK(UJ).book Page 5 Friday, April 19, 2002 6:05 PM