Jwin JT-P870 - Manual (Page 8)

12/19/2003 8:34 AM 8
Caller ID Status Messages
‘UNAVAILABLE’ - This message indicates that the call is made through a telephone
company which does not offer Caller ID service.
‘BLOCKED CALL’ - If the call is restricted, the LCD will display ‘BLOCKED CALL’.
Dial Back Incoming Calls
a) To dial back local calls:
- Use [UP] or [DOWN] to select the desired number.
- Press [DIAL] to confirm. The LCD will display ‘PICK UP HANDSET’.
- Lift the handset or press [SPEAKER], the number will be automatically dialed.
b) To dial back non-local calls and insert a preceding number ‘1’:
After you have pressed [DIAL]:
- If the number you selected is not a local number, the LCD will display ‘PICKUP OR
ADJ’.
- Press [DIAL] once more to include a ‘1’ as the first digit automatically. (Press [DIAL]
twice to cancel adding ‘1’.)
- Lift the receiver or press [SPEAKER] -- the number will be dialed automatically.
Out Going Messages
Record and Play OGM1 (Out Going Message1)
OGM1 is a message that tells the caller to leave a message. The record and play steps are
as follows:
- If no OGM1 message has been recorded, press the [OGM] button once, the telephone
answering message will announce ‘Hello, please leave a message after the tone.’ This
is a default message that accompanies the telephone.
- If you want to record your own OGM1 message, depress [OGM] for about 2 seconds
and release. Start record after hearing a long “beep”.
- Recording will stop automatically after 1 minute or you can stop the recording by
pressing the [PLAY/STOP] button.
- The telephone will immediately play the OGM1 after recording.
- Press [OGM] once to replay the out-going message.
- Press [PLAY/STOP] to stop the message.