John Lewis CONDENSER TUMBLE DRYER JLTDC 09 - Manual (Page 10)

10
• “Cooling”
This light indicates that the appliance is in the cooling
phase. At the end of drying, there is a 10 minute cooling
phase to cool the laundry
.
• “End”
This light illuminates at the end of the cooling phase,
during the anti-creasing phase and at the end of the
programme
.
9 Start/Pause button
Press this button to start the dryer after having selected
the programme and any required options.
The relevant light will stop flashing. If you have chosen a
delayed start, the machine will begin the countdown.
If the door of the appliance or the small door at
the bottom is opened while the programme is
running, this button must be pressed again after
closing the door in order to restart the
programme from the point at which it was
interrupted.
This button must also be pressed after a power failure
and after having re-inserted the water reservoir, if it has
been emptied in the middle of a programme after the
“FULL TANK” light has illuminated.
In both cases the light of the Start/Pause button flashes to
remind you that the start button needs to be pressed
again.
10 Indicator lights
These lights indicate the following functions:
“Filter” light
This light illuminates at the end of the programme to
remind you that the filters must be cleaned.
“Full Tank” light
This light illuminates at the end of the programme to
remind you that the water reservoir must be emptied
out. If this light illuminates during a programme this
means that the water reservoir is full. The buzzer sounds,
the programme stops, the light of the Start/Pause button
flashes
.
“Condenser” light
It comes on every 80 cycles to remind you that the
condenser must be cleaned.
Child safety device
The child lock can be set to prevent a programme being
accidentally started or a programme in operation being
accidentally changed. The child safety device locks all
buttons and the programme knob. The child safety device
can be activated or deactivated by holding down the
“Intensive” and “Half power” buttons simultaneously
for 5 seconds.
• Before programme is started:
Appliance cannot be used
• After programme is started:
Programme in operation cannot be changed
The symbol appears in the display to indicate that the
child safety device is activated.
The child safety device is not deactivated once the
programme comes to an end.
If you want to set a new programme, you must first
deactivate the child safety device.