John Lewis CONDENSER TUMBLE DRYER JLTDC 09 - Manual (Page 19)

19
The tumble dryer does not start
• The door(s) has (have) not been closed.
• The plug is not properly inserted in the power socket.
• There is no current at the socket.
• The main fuse or the fuse in the plug has blown.
• The selector dial is not set correctly.
• The water reservoir is full or not properly inserted (the
FULL TANK light is on ). The programme starts in any
case but it stops after approx. 4 minutes.
• The START/PAUSE Button has not been pressed.
• The DELAY START option has been selected.
Drying takes too long or laundry is not
dry enough.
• The laundry has not been spun properly.
• The filters and/or the condenser are clogged.
• The water reservoir is full.
• The room temperature is too high.
• The selected time or drying cycle was not suitable for
the laundry.
• The HALF POWER button has been pressed.
• There is too much laundry inside the appliance.
• The dryer is not correctly installed.
Something not working
Symptom Solution
If the tumble dryer is not working correctly, please carry out the following checks before contacting your local Service
Force agent.
IMPORTANT: if the END light flashes, the buzzer sounds and an alarm code is displayed, switch the machine off and
call the telephone number given on page 21.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or
installation a charge will be made even if the appliance is under guarantee.
The drum light does not light up: • The Programme/Time selector dial is on position “OFF”.
• The lamp is defective.