JVC UX-P450 - Manual (Page 13)

11
English
Listening to the Radio
To set the AM tuner interval spacing
Before operating the tuner, it is required to select the
appropriate AM space interval used for your area.
1
Select the AM band.
2 Turn off the power.
3 Select the appropriate AM space interval for your
area.
• You can only use the button and the control on the front
panel.
To select the band (FM or AM)
To tune in to a station
While FM or AM is selected...
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency stops changing.
•
When you repeatedly press the button, the frequency changes
step by step.
To stop searching manually, press either button.
If the received FM station is hard to listen
The MONO indicator lights on the display. Reception will
improve though stereo effect is lost—Monaural reception
mode.
To restore the stereo effect, press the button again (the
MONO indicator goes off).
To preset the stations
You can preset 30 FM and 15 AM stations.
1 Tune in to a station you want to preset.
• You can also store the monaural reception mode for FM
preset stations if selected.
2 Activate the preset number entry mode.
• Finish the following process while the indication on the
display is flashing.
Main Unit
ONLY
FM AM
STANDBY/ON
DOWN
STANDBY/ON
AM 9KHZ
(9 kHz interval)
STANDBY/ON
AM 10KHZ
(10 kHz interval)
UP
While holding...
While holding...
FM AM
Remote control: Main unit:
GROUP/TITLE
2 sec. 2 sec.
DOWN UP
Remote
ONLY
FM MODE
9
(at the same time)
Remote
ONLY
SET
Basic.fm Page 11 Wednesday, May 19, 2004 5:52 PM