JVC UX-P450 - Manual (Page 162)

11
Listening to the Radio
To select the band (FM or AM)
To tune in to a station
While FM or AM is selected...
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency stops changing.
•
When you repeatedly press the button, the frequency changes
step by step.
To stop searching manually, press either button.
If the received FM station is hard to listen
The MONO indicator lights on the display. Reception will
improve though stereo effect is lost—Monaural reception
mode.
To restore the stereo effect, press the button again (the
MONO indicator goes off).
To preset the stations
You can preset 30 FM and 15 AM stations.
1 Tune in to a station you want to preset.
• You can also store the monaural reception mode for FM
preset stations if selected.
2 Activate the preset number entry mode.
• Finish the following process while the indication on the
display is flashing.
3 Select a preset number for the station you store.
• You can also use the ¡ or 1 buttons.
4 Store the station.
To tune in to a preset station
1 Select the band (FM or AM).
2 Select a preset number for the station you store.
Remote control: Main unit:
FM AM
GROUP/TITLE
2 sec. 2 sec.
DOWN UP
Remote
ONLY
FM MODE
9
(at the same time)
Examples:
To select preset number 5, press
5.
To select preset number 15,
press +10, then 5.
To select preset number 30,
press +10, +10, then 10.
• You can also use the ¡ or
1
buttons.
Remote
ONLY
SET
AUDIO ANGLE SUB TITLE
ZOOM VFP
FM MODE REV. MODE
DVD LEVEL
1
4
7
10
2
5
8
3
6
9
10
SET
Remote
ONLY
FM AM
AUDIO ANGLE SUB TITLE
ZOOM VFP
FM MODE REV. MODE
DVD LEVEL
1
4
7
10
2
5
8
3
6
9
10
Basic.fm Page 11 Friday, May 14, 2004 7:00 PM