JVC LYT1300-001A - Manual (Page 27)

EN
27
Master Page: Right-Heading0
PLAYBACK MENUS
VIDEO
Playback sound
During tape playback, the player detects the sound
mode in which the recording was made, and plays
the sound back. Select the type of sound to
accompany your playback picture. According to the
menu access explanation on page 26, select
“SOUND MODE” or “DV NARR.” from the Menu
Screen and set it to the desired parameter.
SOUND MODE
(Factory-preset: STEREO )
STEREO : Sound is output from both “L” and
“R” channels in stereo.
SOUND L : Sound from the “L” channel is
output.
SOUND R
: Sound from the “R” channel is
output.
DV NARR. (Factory-preset: OFF)
OFF: Original sound is output from both “L” and
“R” channels in stereo.
ON: Dubbed sound is output from both “L” and
“R” channels in stereo.
MIX: Original and dubbed sounds are combined
and output in stereo on both “L” and “R”
channels.
NOTES:
● You can also use AUDIO button on the provided
remote control ( ੬ pg. 37) to change the output
sound (without having to access the Playback
Menu).
● The “SOUND MODE” setting is available for both
12-bit and 16-bit sound. (In previous models’
functions, “12-bit” is called “32 kHz” and “16-bit”
is called “48 kHz”.)
● The player cannot detect the sound mode in which
the recording was made during fast-forward or
rewind. During playback the sound mode is
displayed in the upper left corner.
Recording mode
Allows you to set the video recording mode (SP or
LP) depending on your preference. It is
recommended you use “REC MODE” in VIDEO
Menu when using this player as a recorder during
dubbing. (
੬ pg. 32, 34)
REC MODE (Factory-preset: SP)
SP / LP
Dubbing from tape to memory card
COPY (Factory-preset: ON)
OFF: When the SNAP SHOT button is pressed
during tape playback, the playback image pauses
and normal playback will resume after
approximately 6 seconds. (The still image is not
recorded.)
ON: Enables dubbing of images recorded on a
tape to a memory card. (
੬ pg. 36)
Deleting thumbnail images
For details, refer to “To delete thumbnail images”
(
੬ pg. 31).
NAVI.DEL.
IMAGE SEL. / TAPE SEL. / ALL / RETURN
S-Video/AV input
S/AV INPUT (Factory-preset: OFF)
OFF: Enables audio and video signal output to a
TV, VCR, etc. via the AUDIO (L/R) and VIDEO or
AUDIO (L/R) and S connectors. (
੬ pg. 18, 32)
ON: Enables audio and video signal input from
the AUDIO (L/R) and VIDEO connectors, or audio
and S-video signal input from the AUDIO (L/R)
and S connectors. (
੬ pg. 32)
NOTE:
When VIDEO and S connectors are simultaneously
connected, S-video signal is input from the S
connector.
Video Menu
AD
V
A
NCED FE
A
TURE
S
CU-VH1E.book Page 27 Friday, March 26, 2004 1:55 PM